Doubly_fed_windfarm

cs的kvsd标准算法，以及kvsd_nn的改进算法(cs of kvsd standard algorithms, as well as improved algorithm kvsd_nn)

说明：  pic控制的led灯的循环点亮模式，八个LED，高电平点亮，可用于I/O口及其它信号状态的观测。(pic control led cycle lights lit mode, eight LED, high light, can be used for I/O signal state of the mouth and other observations.)

把0~5v的电压值转换到0~100度的温度，并用51液晶显示，采用keil仿真(0 ~ 5v voltage value is converted to a temperature of from 0 to 100 degrees, and with 51 of liquid crystal display, using keil simulation)

采用MSP430G2553和12864液晶实现控制界面，可控制端口输出不同频率的脉冲波形，同时还可测量不同信号的电压值(12864 achieved using MSP430G2553 and control interface, you can control the port output pulse waveforms of different frequencies, but can also measure the voltage values ​ ​ of different signals)

EX49_STEP MOTOR IR 红外遥控步进电机演示程序 使用红外遥控器对步进电机的转动方向和速度进行控制 通过1602液晶显示红外遥控器键值编码，(EX49_STEP MOTOR IR Infrared remote control stepper motor demo program Use infrared remote control to control the stepper motor rotation direction and speed 1602 LCD infrared remote control key coding)

Biomedical signal processing and analysis

说明：  nrf24l01的驱动程序，可以用于2.4g盒子的超强通信。支持收发和1对6(NRF24L01 driver can be used for 2.4G box super communication. Supporting transceiver and 1-to-6)

pcf8591原理图（adda转换模块开发）(pcf8591 Schematic (adda conversion module development))

用于STM8系列芯片的BQ24295芯片驱动代码，用于控制单节锂电池的充放电管理，使用了“STM8S_StdPeriph_Lib_V2.2.0”库函数用于IO配置，使用了虚拟I2C和虚拟SPI端口控制(code be used to drive bq24295 on stm8, can control one li-on battery charge and discharge, the code based on "STM8S_StdPeriph_Lib_V2.2.0" library(for config the IO), based on virtual spi and i2c.)

说明：  这是用BP神经网络搭建实现PID控制器的模型，是本人的呕血之作(This is set up by BP neural network model for the realization of PID controllers is to make of my hematemesis)