MSChart

当时间到时，蜂鸣器提醒，并有音乐提示。 时间可以自己设定，可以最小化到托盘。(time)

配电网零序电流故障定位方法在PSCAD中的模型搭建，可以调整故障类型和短路电阻等进行故障模拟(The fault location method of zero sequence current in distribution network is built in PSCAD, which can adjust the fault type and short circuit resistance. )

基于ATmega8 的ucos-II应用(ATmega8' s ucos-II-based applications)

74hc595芯片的使用 51控制595芯片的io拉高(74hc595 chips 595 chips using 51 control pulled io)

24L01无线模块的驱动程序。包含发射与接收的程序。(24L01 wireless driver module. Contains the transmitting and receiving program.)

STC12C5204AD单片机控制单个二极管闪烁源代码，二极管由138译码器使能，另一端单片机IO口控制，采用延时程序，是单片机初学者很好的学习源代码(STC12C5204AD flash microcontroller source code to control a single diode, diode 138 by the decoding is enabled, the other end of the single-chip IO port control, using the delay procedure is a very good chip for beginners to learn the source code)

vb驱动控制器源代码就这样啦 具体自己看吧(vb drive controller source code)

计算配电网络潮流 基于40节点计算配电网潮流电压及其电流 (Calculation of distribution network based on 40 tide node voltage and current power flow calculation)

此文件夹有高通滤波，低通滤波，带通滤波，带阻滤波，三角信号发生器，正弦信号发生器，三角波发生器，三角波转换成余弦，等等tina的源程序，适合广大爱好者！(This folder has a high pass filter, low pass filter, band-pass filtering, band stop filtering, triangular signal generator, sine wave generator, triangle wave generator, triangle wave into a cosine, so tina source for the majority of fans !)

12F629开发的中控锁,可以控制两个继电器.带学习功能(Lock 12F629 developed to control the two relays. With learning function)