PV

说明：  bergeron仿真贝吉龙过程，温度低于0℃且过冷却水滴、冰晶、水汽共存的云区，由于冰面的饱和水汽压低，而水面的饱和水汽压高，因此便会有这样的情况出现，即当云中的水汽压处于冰面和水面饱和值之间时，水汽在冰晶上凝华而使冰晶长 大，而水滴会不断蒸发变小或消失，形成冰晶“ 夺取”水滴的水分和原来云中水汽的冰水转化过程。(The saturated water vapor pressure of the bergeron surface is high, so there will be a situation where the water vapor in the cloud is between the ice surface and the saturation value of the water surface, the water vapor condenses on the ice crystals and causes the ice crystals to grow, and the water droplets will The evaporation continues to become smaller or disa)

MIMO未知输入观测器的matlab仿真 simulink方法实现(MIMO unknown input observer)

用DSP汇编语言进行医学图像的FFT处理(Using DSP assembly language for medical image processing FFT)

对GPS和DR组合导航的数据进行卡尔曼滤波处理(The GPS and DR integrated navigation Kalman filter data processing)

信号的边际谱分析程序，从振动论坛看到的 ，和大家分享(marginal spectrum for time series)

This code is to plot data in Weibull distribution format

利用GPS观测和精密星历，采用多项式或球谐函数模型的方法进行建模，能够同时估计接收和卫星DCB，在此基础山计算电离层TEC,为导航单位提供电离层延迟改正(Using GPS observation and precise ephemeris, or methods using spherical harmonic polynomial function model to model, simultaneously estimates the reception and satellite DCB, calculated on the basis of the mountain ionosphere TEC, provide ionospheric corrections for the navigation unit delay)

《CMD文件的原理》 by玄德。对DSP深入学习有很大帮助。(《The Principle of CMD file》 by Xuan. It s very helpful to deeply study DSP.)

本实验利用蒙特卡洛分析方法，通过MATLAB仿真了QPSK,16QAM基带传输系统AWGN和Rayleigh信道下的系统BER性能。仿真过程中通过，m文件的编写，将两个基带系统仿真的结果画在了一张图上(In this experiment, the BER performance of QPSK, 16QAM baseband transmission systems in AWGN and Rayleigh channels is simulated by using Monte Carlo analysis method and MATLAB. In the process of simulation, the simulation results of two baseband systems are drawn on a graph by compiling m files.)

说明：  基于TMS320F28335的MODBUS-RTU从站程序(MODBUS-RTU slave program based on TMS320F28335)