TQWZZB

VSP褶积模拟模型，通过时距曲线模拟vsp褶积模型(VSP convolution simulation model, through simulation vsp distance curve convolution model)

几个经典用C#画图的例子，包括正弦和曲线图形，很实用的，在VS2008下运行过(Several classic examples of C# drawing, including sine and curve graphics, very practical, run under the VS2008)

MFC画图程序,实现动态画直线、椭圆等功能(MFC drawing procedures, to achieve dynamic painting a straight line, oval and other functions)

克里金插值计算，一种拟合算法，主要用于等值线应用。(Kriging interpolation calculation, a fitting algorithm, mainly for the application of contour lines.)

说明：  详细用法请看文件说明，该程序用matlab编写，挂用vc＋＋编译器编译而成，程序用途：找出在任意多变形内的象素点(detailed document indicates that the procedures used to prepare Matlab, linked with vc++ compiler compiler which, procedures purposes : to identify more arbitrary deformation within the pixel point)

cad提取文字坐标 能提取文字所在点的坐标值并保存到text中 (cad text extraction coordinates coordinates of the text can be extracted and saved to the point where the text of the)

基于autolisp快速绘制钢结构（尤其钢箱梁）横断面(Rapid Drawing of Cross Sections of Steel Structures (especially Steel Box Girders) Based on Autolisp)

利用mathcad计算齿轮啮合刚度系数，详实说明，自己编写(Calculated using the gear meshing stiffness coefficient mathcad, detailed instructions, write by myself)

多重分形去趋势来分析处理生物医学信号，matlab程序代码(Multifractal detrended)

这是国外的同行编写的画图板程序，感觉比陈建春的要好些，说实话研究了半天，发现国内的cad水平低不是因为国内的人笨，主要是国外的cad技术不能很快的传递到国人手中，总是参考陈建华等水平有限，工程水平差的书籍造成整体水平低，书中没有详细的流程图，和软件设计思路，而且代码错误连篇。(This is the foreign counterparts of the drawing board to prepare procedures, CHEN Jian-chun than feeling the need to better tell the truth for a long time study and found that low levels of domestic cad because people are not stupid, mainly abroad cad technology should not quickly delivered to the the hands of the people always refer to Chen Jianhua, such as the limited level, engineering level difference caused by the overall level of books low, the lack of a detailed flow chart of the book, and software design, and code errors pack.)