road-segmentation

求零点、极点和增益，这是一些已经调好的实例，还有运行后的结果。(For zero, poles and gain, this is some have adjustable good examples, and after the operation result. )

说明：  design pI controller and anther file to the system without controller , this two program tracking the the input but the system without PI controller can t tracking .

this code described by Matlab file for fitting process for the extract a ellipse curve from the 2D noisy ellipse image.

一种铅笔画绘制的新方法，MATLAB环境，对非真实感有帮助(A pencil drawing of the new method, MATLAB environment, help for non-photorealistic)

signal for PC software

Matlab based Wireless card (GPRS/WLAN) driver. or optionally a Bluetooth connection to a GPRS modem

a simple widrow hoff implementatiion

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

信噪比最大化的盲源分离代码，可用于分离源信号数与混合信号数一样的情况。(Separated source signal number and the number of mixed-signal can be used to the SNR maximization blind source separation code.)

System CBIR in Matlab