ABBot_10

STC MCU + TM1812应用开发案例程序(STC MCU + TM1812 application development case program)

硬件电路比较简单，3个LED指示灯，5个按键控制上下左右及暂停，LCD显示。总共有20关。设计用到了逻辑门控制电路。(The hardware circuit is simple, 3 LED lights, 5 key control above and below and suspension, LCD display. A total of 20 customs. The design used in the logic gate control circuit. )

AVR各种应用小例程,包括各种常用传感器，液晶，步进电机，语音等等(AVR application, common sensors, LCD,stepper motor,voice, etc.)

说明：  PIC16f1947驱动TM1620数码管芯片(PIC16f1947 Drives TM1620 Digital Tube Chip)

说明：  msp430单片机的毫伏表程序，四位数码管显示(msp430 microcontroller millivoltmeter program, four digital tube display)

仅使用一个热敏电阻和一个10K电阻、104电容，在MSP430上实现的精度可达0.1度的温度测量代码。(Only using a thermistor and a 10K resistor, capacitor 104, temperature measurement code achieved accuracy up to 0.1 degree on the MSP430 .)

说明：  这是基于开发板LPC1114的源码程序，是用C语言编写，关于液晶显示屏的配置和实现同时它也是一个完整的模板，可以在此基础上添加其他程序用于开发板的学习，是一个完整的模板，可直接使用。(This is based on the development board LPC1114 source code program, is written in C language, on the LCD display configuration and implementation at the same time it is a complete template, you can add other programs on this basis for the development board learning, is a complete template, can be used directly.)

一个用430单片机设计的温控仪表电路图方案。采用protelse99设计的，里面只有电路图、没有pcb图。(A single chip with a 430 temperature controller circuit design program. Designed by protelse99, only the circuit, no pcb diagram.)

机器人技术等级考试，电机调速程序,针对aduino单片机的，简单的小程序，红外遥控(Motor speed regulation program)

基于STM32F10X的气压传感器（bmp180）程序，串口输出，内含bmp180手册。(Based STM32F10X pressure sensor (bmp180) program, serial output, containing bmp180 manual.)