Introduction_to_the_Altera_SOPC_Builder

恩智浦NXP LPC1788 Cortex M3嵌入式开发官方资料。其中包括，官方例程，底层驱动，及其使用说明书等资料。(NXP LPC1788 Cortex M3 embedded development official information. Including, the official routines, the underlying driver, and its instruction manual and other information.)

STM8单片机的SPI主从通信，一个STM8单片机当主机，另一个STM8单片机当从机，基本实现了SPI的所有功能，特别适合对SPI的深入理解。(STM8 microcontroller SPI master or slave communication, a STM8 microcontroller as host another STM8 microcontroller from the machine, the basic realization of all the features of the SPI, especially for in-depth understanding of the SPI.)

内含九个独立工程，主控芯片 STM32F108C8T6。九个工程分别为：操作LED灯；操作485；操作ADS1015 12位ADC芯片；操作济南有人的网口；两个版本的PID控温程序；外部时间程序；操作ch376读写SD卡程序；ucos-II+mudbus测试程序。(Contains nine independent works, master control chip STM32F108C8T6.The nine projects are: operating LED lamps;Operations, 485;Operation ADS1015 12 bit ADC chip;Operate a network of people in jinan;Two versions of PID control program;External time program;Operation ch376 to read and write SD card program;Ucos -II+mudbus test program.)

ALIENTEK MINISTM32 RTC

01.03.05.06码进行读写，实现触摸屏按钮和数字输入通过485在实验板上显示数字，和点亮LED(01.03.05.06 code for reading and writing,)

propeller clock source code

准备两个CAN板子，连接两个CAN接口，两个板子都下载本程序。 本实验通过CAN总线控制另外一个板子的LED2~LED5闪烁的例子，如果通信正常可以看到两个板子的LED都再闪烁， 如果通信失败或者断开通信线，LED不再闪烁(Prepare two CAN board, connecting the two CAN interface, two board are download the program. This experiment through the CAN bus control another board LED2 ~ LED5 flashing example, if communication normal CAN see two board LED twinkle again, If communication failure or off the line, LED will no longer flash)

Harmonic Balance simulation

说明：  基于2812电机调零程序，可定位永磁同步电机零点(Based on the 2812 motor zero adjustment program, the PMSM zero point can be located.)

说明：  AVR单片机控制DA芯片TLC5615，输出正玄波(AVR microcontroller controls Da chip TLC5615 to output sine wave)