kaiti

EEPROM 多位地址数据随机，连续读写(I2C protocol between C51 MCU and EEPROM)

在51单片机中用C语言描述IIC总线的功能，以LED发光二极管表现(51 single-chip using C language to describe the functions of the IIC bus, the LED light-emitting diode performance)

DS1302+DS18B20+无线遥控应用程序(DS1302+ DS18B20+ wireless remote control applications)

针对以删为微处理器的逆变器数字控制系统，本文在深入分析逆变电源 技术理论及实验需求的基础上，对整个硬件系统平台进行了详细的设计，研制 了一台直流输入电压24V，输出电压为AC220V、额定功率600VA的单相正弦 逆变器样机。(For to delete inverter microprocessor digital control system, in-depth analysis of this paper Inverter Theoretical and experimental basic technology needs on the entire hardware platform in detail the design, development With a DC input voltage of 24V, the output voltage is AC220V, rated single-phase sinusoidal power 600VA Inverter prototype.)

使用led和1602显示时间日期和当前环境温度。温度采集使用开发板载传感器。(Led and display time using the 1602 date and the current ambient temperature. Temperature Acquisition using the development of on-board sensors.)

使用CAN读取毫米波雷达数据，编写语言为C(Reading millimeter wave radar data using CAN)

说明：  串口的发送和接受程序，板子上实验通过，和大家分享。(Send and receive serial procedures, the experiment through the board, share with you all.)

基于m16的温度控制系统，主要用ds18b20(failed to translate)

用Visual C++ 6.0实现的一个VSP程序。包你看后受益匪浅。(with Visual C 6.0 of a VSP procedures. After looking at the package you benefited.)

51单片机发送，三星的S3C2440接收，并点亮led小灯，通信波特率是115200，单片机采用定时器2来实现该波特率(51 SCM to send, samsung s S3C2440 receiving, and lit led lights, communication baud rate is 115200, microcontroller timer to achieve this by 2 baud rate )