Neville--interpolation

该模型描述的是zeta变换器。控制方式为电感电流控制。分析在一组参数下的非线性现象，画出相图，时域图，观察从周期一到周期二最后进入混沌状态(The model describes the zeta converter. Control mode for inductance current control. Analysis in a group of parameters of the nonlinear phenomenon, draw the phase diagram, time domain chart, observation from cycle to cycle a second finally into chaotic state )

This package enables Gaussian process prediction with very large sample sizes with a much smaller computational burden than many existing methods.

matlab下的小波消噪源程序，能较好的对非平稳信号进行滤波消噪(matlab source code under the wavelet denoising can be better to filter the non-stationary signal denoising)

介绍matlab相关语言与控制系统仿真，具体内容有计算机辅助设计与仿真技术概述，matlab语言基础，控制系统的数学描述与建模，控制系统的分析方法，SIMULINK仿真基础等等。(Introduction matlab simulation and control systems related to language, the specific content of an overview of computer-aided design and simulation, matlab language based on mathematical description and control system modeling, control system analysis, SIMULINK simulation-based, and so on.)

rayleigh fading channel matlab codes

new principle in RADAR and LIDAR with pulse compression and ifft and fft

gcv.m GCV准则。。。。。。。。。。。。。(gcv.m GCV principle....................)

说明：  m序列相关性研究比较，m序列的产生方法， m序列自相关性函数的应用(m_sequence generate m_sequence correlation comparing )

席位分配的matlab例程，可以勾选多种算法以方便练习使用(The distribution of seats in matlab routines, you can check a variety of algorithms to facilitate the use of practice)

大功率分布式发电系统通常采用三相逆变器并网，由于三相逆变器系统参数耦合，传统方法设计的控制器算法复杂。在d。q坐标系下为双模式三相并网逆变器的独市和并网模式建立了数学模型．采用新的解耦方法，依据独立和并网模式控制系统超调量越小，模式切换过程中被控量的波动越小。切换过程就越平滑的原则。完成了两种模式的控制器设计，即分别应用积分环节、比例环节即可将独立模式和并网模式整定成典型的二阶系统，控制器设计简单．能取得优良的动、静态特性。仿真与实验验证了设计方法的正确性和可行性。(It is necessary to research on three—phase grid-connected inverter which a8 an important part of distributed generation．The parameters of three—phase inverter are coupling．The traditional design algorithm of the controller is complicated．The mathematicM models of stand—alone mode and grid—connected mode are established in d，q fhme． Based on the principle that the lower overshoot of the controller system，the smaller fluctuation of the controlled vailables， the smoother in transfer，controllers of two modes are designed separately，as integral and proportional regulators are separately added to stand-alone mode and g而d—connected mode．The controller has good dynamic and static char— acteristics．Simulation and experimental results varify the correctness and feasibility of the proposed method．)