-
KMP-in-matlab
matlab kmp source code
- 2013-07-09 13:30:49下载
- 积分:1
-
WIRELESSCOMMUNICATIONS
斯坦福大学的Andrea Goldsmith写的经典之作!适合研究生及以上学历人阅读!(Stanford University Andrea Goldsmith to write! For graduate students or above to read!)
- 2010-06-01 16:08:37下载
- 积分:1
-
yuzhongmeng-compressive_sensing-master
说明: 用matlab平台编写基于压缩感知的信道估计重构算法的实现(Implementation of channel estimation reconstruction algorithm based on compressed sensing)
- 2021-03-27 13:29:12下载
- 积分:1
-
LMS_gai2
两个频率的凹口滤波对消干扰噪声,效果很好。希望大家仿真实验。(Two frequency notch filter to eliminate interference noise, the effect is very good. I hope everyone simulation experiments.)
- 2013-03-10 18:59:46下载
- 积分:1
-
47538419-SCWCD-5-0-310-083-Latest-Dump
SCWCD Question Papers
- 2015-01-07 04:08:29下载
- 积分:1
-
bowenguangheji
将波纹钢板桥涵结构简化为单位宽度的固支圆弧梁,同时考虑波纹钢板桥涵结构和土的共同作用,首次建立了该结构的计算模型,推导了该结构位移、应力的解析解.实例计算结果表明:理论计算结果和现场实测结果相当吻合.在此基础上,编制MATLAB程序,进一步分析波纹板厚、波峰高度、波长、结构半径,土体自重、侧压力系数,以及弹性模量对结构位移、应力的影响,为该结构优化设计和施工提供了理论依据.(The simplified structure of corrugated steel culvert unit width clamped circular beam, taking into account the corrugated steel culvert structure and interaction of soil for the first time to establish a computational model of the structure, the structural displacement derived analytical solution of stress. Example calculation the results show that: the theoretical calculations and field measurement results are quite consistent on this basis, the preparation of the MATLAB program, further analysis of corrugated sheet thickness, wave height, wavelength, structure radius, the weight of soil, lateral pressure coefficient, and elastic modulus of the structure. displacement, the impact of stress for the structural optimization design and construction provides a theoretical basis.)
- 2014-01-10 17:32:08下载
- 积分:1
-
IeeeTransactionsOnWirelessCommunications-Equalizat
描述EDGE系统接收机结构,包括prefilter和均衡器(Description EDGE receiver structure, including the prefilter and the equalizer)
- 2009-03-02 16:10:17下载
- 积分:1
-
re1
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:51:25下载
- 积分:1
-
2010-matlab-5
2010 数学建模大赛 赛前matlab培训5(2010 Mathematical Contest in Modeling Training (numerical entry) lecture 5.zip)
- 2013-11-11 23:26:31下载
- 积分:1
-
PID_PARTDIFF
不完全微分PID算法Matlab仿真程序。适用于控制理论领域。(Incomplete differential PID algorithm Matlab simulation program. Applicable to the field of control theory.)
- 2014-01-09 21:03:32下载
- 积分:1