ScalarControl-asynchronous-motor

“基于Floyd最短路算法的Ford和Fulkerson迭加算法”的最小费用最大流算法，其基本思路为：把各条弧上单位流量的费用看成某种长度，用Floyd求最短路的方法确定一条自V1至Vn的最短路；再将这条最短路作为可扩充路，用求解最大流问题的方法将其上的流量增至最大可能值；而这条最短路上的流量增加后，其上各条弧的单位流量的费用要重新确定，如此多次迭代，最终得到最小费用最大流。 (" Floyd shortest path algorithm based on the Ford and Fulkerson algorithm superposition" of the minimum cost maximum flow algorithm, the basic idea is: the flow of each arc on the unit cost as a length, with Floyd for the most short-circuit method to determine a from V1 to Vn of the most short-circuit then this can be expanded as the shortest way, by solving the maximum flow of traffic on the way to its maximum possible value and this increased the flow of the shortest path, on which the arcs of the unit to re-determine the cost of traffic, so several iterations, finally get the minimum cost maximum flow.)

QPSK系统的误码率仿真，运用MATLAB编程(QPSK BER simulation, using MATLAB programming)

This module provides an introduction for our ELEC 301 DMT group project. 这是其中a2d模块部分(This module provides an introduction for o ur ELEC 301 DMT group project. This module is part of a2d)

通过降噪自动编码器对心电信号的单心拍进行降噪，效果良好。(By noise automatic encoder ECG single heart beat for noise reduction, to good effect.)

MATSLISE is a Matlab application for the numerical study of Schringer and Sturm-Liouville problems. MATSLISE allows one to compute the eigen- values and eigenfunctions and to display them graphically. The numerical methods used are the CP methods (abbreviation for Constant reference potential Pertubation Method). (MATSLISE is a Matlab application for the numerical study of Schr鰀inger and Sturm-Liouville problems. MATSLISE allows one to compute the eigen- values and eigenfunctions and to display them graphically. The numerical methods used are the CP methods (abbreviation for Constant reference potential Pertubation Method). )

modified 180 voltage souce inverter similar to p.s.bimbra circuit

無監督分類方法，可以對一堆數值自動的歸類(Unsupervised classification methods, can be a pile of automatic classification of numerical)

Permanent magnet synchronous motor model in MATLAB

初步学习采样和重建信号。包括源程序和报告书。(Preliminary study of sampling and reconstruction of the signal. Including the source and report.)

This program is used to Calculate z transform, s transform..etc