-
fft
Matlab程序,GUI窗口
用FFT程序计算有限长度正弦信号y=sin(2*pi*f*t) ,0<=t<=N*T(FFT program calculate the finite length of the sinusoidal signal y = sin (2* pi* f* t), 0 < = t < = N* T respectively the DFT results obtained and analyzed and discussed in the following cases: a) the signal frequency f = 50Hz, the sampling the credited with N = 32, the sampling interval T = 0.000625sb) signal frequency f = 50Hz, the sampling points of N = 32, the sampling interval T = 0.005sc), the signal frequency f = 50 Hz, the sampling points N = 32, the sampling interval T = 0.0046875sd) signal frequency f = 50Hz, the sampling points of N = 32, the sampled interval T = 0.004se) signal frequency f = 50Hz, the sampling points of N = 64, the sampling interval the T = 0.000625sf) signal frequency f = 250Hz, the sampling points N = 32, the sampling interval T = 0.005sg) c) a signal-post 32, to do a 64-point FFT)
- 2013-04-11 21:58:54下载
- 积分:1
-
OFDM
有详细的OFDM的LS,MMSN算法,注释,允许结果均有效(Detailed OFDM-LS, MMSN algorithm, notes, allowing the results are valid)
- 2013-11-14 19:20:14下载
- 积分:1
-
lengpan
详细画出了时域和频域的相关图,包括面积、周长、矩形度、伸长度,采用的是脉冲对消法。( Correlation diagram shown in detail the time domain and frequency domain, Including the area, perimeter, rectangular, elongation, It uses a pulse of consumer law.)
- 2016-07-30 23:04:57下载
- 积分:1
-
FBG
program on BAR TRANSMISSION,CROSS TRANSMISSION, FBG SPECTRUM
- 2009-11-04 01:01:16下载
- 积分:1
-
Fisher
fisher 图片处理报告,程序搜索Fisher program(fisher image processing reports, program searches Fisher program)
- 2013-07-14 14:14:40下载
- 积分:1
-
ncofdm_multipath
NC-OFDM在六径瑞利衰落信道下的性能分析(NC-OFDM in the six path Rayleigh fading channel performance analysis)
- 2011-10-21 10:53:45下载
- 积分:1
-
Final_1
malarial detention parasites related matlab code
you can find image segmentation techniques
- 2014-12-21 01:14:35下载
- 积分:1
-
pv_model_STF100P6_Solar_1_Panel
Matlab Codding for Solar PV panel
- 2015-03-02 15:34:21下载
- 积分:1
-
irisok
Matlab program for IRIS RECOGNISATION
- 2013-05-04 16:48:06下载
- 积分:1
-
clc
A cyclic redundancy check (CRC) is an error-detecting code designed to detect accidental changes to raw computer data, and is commonly used in digital networks and storage devices such as hard disk drives. Blocks of data entering these systems get a short check value attached, derived from the remainder of a polynomial division of their contents on retrieval the calculation is repeated, and corrective action can be taken against presumed data corruption if the check values do not match.
- 2011-08-03 16:31:53下载
- 积分:1