Circuit-Breaker-Diagnostic

bayes分类，matlab实现。可以实现数字的识别(matlab guiyi)

说明：  都是关于空间普估计算法，其中有解相干和非相干算法以及它们之间的对比( the spatial spectrum estimation)

该程序主要用于LTE信道建模，支持8*8天线下的信道模型，包括说明文档(The program is mainly used for LTE channel modeling in support of 8* 8 channel model under the antenna, including documentation)

matlab有关遗传算法的源程序，并且内含有智能算法原理与应用的PPT.(matlab source of genetic algorithms, and the principles contained PPT intelligent algorithms and applications.)

基于遗传算法优化神经网络，主要功能是用于曲线拟合(Neural network optimization based on genetic algorithms, the main function for curve fitting)

说明：  国外牛人写的串口代码，好东西大家分享，强力推荐(Foreign cattle were written serial code, good things to share with you, highly recommended)

说明：  支持向量机（Support Vector Machine, SVM）是一类按监督学习（supervised learning）方式对数据进行二元分类的广义线性分类器（generalized linear classifier），其决策边界是对学习样本求解的最大边距超平面（maximum-margin hyperplane）(Support Vector Machine, SVM)

自适应逆控制的MATLAB m文件 很有用自适应逆控制的程序(Adaptive inverse control of MATLAB m file is very useful adaptive inverse control program)

LBM方法求解流体力学中的圆柱扰流问题，输出动态流场图。(LBM method for solving fluid turbulence in the cylinder problem, the output dynamic flow diagram.)

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)