Function-signal-generator-

STM32F103屏幕显示代码，用于正点原子开发板，2.8与3.5寸TFTLCD屏幕适用(STM32F103 screen display code for punctuality atomic development board, 2.8 and 3.5-inch screen for TFTLCD)

说明：  高级例程-基于MINI板的 呼吸灯效果 采用TIM1的PWM实现；基本例程-USART收发；基于STM32的USB程序开发笔记(Advanced routine - the effect of breathing lamp based on mini board is realized by TIM1 PWM)

这是有关pwm的控制，可以控制它周期的长短来控制灯的亮度，还可以控制它自动调光。(This is the control of the pwm, the length of the cycle it can be controlled to control the brightness of the lights can also control the automatic dimming.)

基于单片机STC59C52的温湿度控制，开题报告(Based on SCM STC59C52 temperature and humidity control, opening report)

硬件平台为MSP430f149,软件平台为IAR，温度传感器为18B20,能实现对温度的实时监测(Hardware platform for MSP430f149, software platform for IAR, temperature sensor 18B20, can achieve real-time monitoring of temperature)

这是一个STM32的示波器显示设计，可以采样指定的接口来实现示波器的显示(Design and experimental code oscilloscope display)

这是 关于STM32单片机 PWM电机调速的 例程文件(this is about stm32 pwm )

利用Keil C51 和LabVIEW编写程序实现PC与单片机串口通信。 设计任务 PC通过串行口将数字（00 ，01 ，02，03... ，FF，十六进制）发送给单片机，单片机收到 后回传这个数字，PC接收到回传数据后显示出来，若发送的数据和接收到的数据相等，则串 行通信正确，否则有错误。启始符是数字00，结束符是数字 FF。(Use Keil C51 and LabVIEW programming to achieve PC serial communication with microcontroller. Displayed after the PC via the serial port design task digital (00, 01, 02,03 ..., FF, hex) is sent to the microcontroller, the microcontroller receives return this figure, PC receives the return data , if the data sent and received data are equal, the serial communication is correct, otherwise an error. Startup character is a number 00, the end of the character is a number FF.)

一个简单的串口示波器，使用的时候请首先安装labview 的visa驱动 此文件为labview2014创建，请使用不低于labview2014的版本打开使用。(a simple OSC using serial port)

说明：  stm32f103zet6 使用freertos，在IAR平台下开发，队列例程(stm32f103zet6 freertos)