Wind-power-bearing-test

正弦波电流驱动的无刷直流电机性能分析，通过分析方波电流驱动与正弦波电流比较，得出正弦波电流驱动电机性能较好(Sine wave current drive brushless DC motor performance analysis, by analyzing the square-wave current drive with sine wave current comparison, the sine-wave current drive motor performance is better)

six phase induction motor with field orent control

F2812 标准FFT算法,128点,256点,512点,1024点FFT算法,具体做法为将库含数FFT.LIB加入的目标项目,加入对应的C含数和头文件,特别注意的FFT算法缓冲去一定要存放在0X8000H中的内部缓冲区中!!!切记,本人调试时就走了很多弯路啊(F2812 standard FFT algorithm, 128 points, 256 points, 512 points, 1024 points FFT algorithm, and the specific practices for the library contains several FFT. LIB to join goal project, to join the corresponding C contains several and head files, pay special attention to must buffer FFT algorithm in 0 X8000H of internal buffer!!!!!!! Remember, I go a lot when debugging detour ah )

读取excel表格中的数据，并在labview中通过曲线的形式进行体现(read the data the excel)

对机械故障诊断的现代信号处理方法作了详细说明，希望大家可以使用多种方法。(For mechanical fault diagnosis of modern signal processing methods are explained in detail, I hope you can use a variety of methods.)

基于DSP5509的SDRAM应用实例，含有CCS4环境下的编程源代码(DSP5509 SDRAM example based on the CCS4 environment)

优点：1，PPI协议通讯速度快，比OPC ，PCAccess，Modbus 快4-5倍左右。(就这一条优点就足了，呵呵) 2，PLC端无需编写任何通讯程序。 3，可以直接对PLC进行，RUN STOP等操作。 4，本程序全部采用LABVIEW底层程序框图，没用调用任何的DLL ，API等。这点对你学习还是修改程序功能都很有帮助，方便。 (Advantages: 1, PPI protocol communications faster than OPC, PCAccess, Modbus about 4-5 times faster. (On which an advantage on the feet, huh, huh) 2, PLC-side without writing any communication program. 3, can be carried out directly on the PLC, RUN STOP operation. 4, the procedure used in all LABVIEW underlying the block diagram, useless to call any DLL, API, etc. This is for you to learn or modify the program features are very helpful and convenient.)

ti 的Tms320F28xx的在线仿真内核.gel文件！(ti' s Tms320F28xx online simulation kernel. gel file!)

串口的接收和发送，labview编程，学习visa的配置，写入，读取，关闭等功能(test the serial ports programming)

在Labview前面板中输入任意三个数，可比较得出最大值，并输出显示。(Enter any three numbers in the front panel of Labview to get the maximum value and output the display.)