AndroidDLAN

PLL锁相环 输入三相电压电流 输出电角度 DQ轴电压电流(Phase Loop Lock Input: 3_phase voltage¤t output: angle & DQ-axis Voltage&Current)

Entities manipulation in autolisp

说明：  在STM32F103RET6测试，FreeRTOS版本V10.0.1，STM32固件版本V3.5。 连接MQTT正常订阅接收数据，修user_mqtt.h头文件即可使用。(In stm32f103ret6 test, FreeRTOS version v10.0.1, STM32 firmware version v3.5. Connect to mqtt, subscribe to receive data normally, and repair user_ The mqtt. H header file can be used.)

亲测ZLG-LPC1788开发板上RT-Thread的最小系统模板（LwIP开启） LPC1788基于RTT源码实现的模板程序(Pro-test ZLG-LPC1788 development board minimum system RT-Thread template (LwIP open) LPC1788 RTT source template-based program implementation)

simulink of PID control for quadrotor

SileadTouch.fw for Onda 820

基于atmega16v8的TC1查询方式控制LED(Atmega16v8 TC1 query mode control based on LED)

义隆单片机EM78P153SN 程序 100US延时 汇编语言(Elan microcontroller EM78P153SN program 100US assembly language delay)

通过 Modbus 通讯 RS485 型物理链路，或装有适当变换器的其他接口使 Sepam 能 与远程监控系统连接。 Sepam 采用的 Modbus 规约与 RTU Modbus (1) 规约的子集兼容 ( 一个 Modbus 主 机可以同多个 Sepam 单元通讯 )。 Sepam 永远是子机 ( 从站 )。 所有 Sepam 单元均可配置 ACE949-2 ( 二线 ) 或 ACE959 ( 四线 ) 接口与通讯网络 连接。 RS485 和 ACE937 可连接到通讯网络，光纤通讯星形系统。(Communication via Modbus RS485 type physical link, or fitted with suitable converters other interfaces can make Sepam Connection with a remote monitoring system. Sepam uses a subset of the Modbus protocol with RTU Modbus (1) of the Statute compatible (a Modbus master Machine unit can communicate with a plurality of Sepam). Sepam is always a slave (slave). All Sepam unit can be configured ACE949-2 (wire) or ACE959 (four-wire) communications network interface connection. RS485 and ACE937 can be connected to the communications network, fiber-optic communication star system.)

能实现对方波频率进行采集，能够采集低频到100K左右的方波(It can collect square wave frequencies from low frequency to about 100K.)