MIMO-detector

Ds_CDMA EASI 算法使用两个用户的分离实现PN序列以及用户信息的分离(To solve the problem of the direct sequence code division multiple access (DS-CDMA) system multiuser detection, this paper proposes a variable step-size based on performance index (PI) EASI algorithm for information code and chip sequence blind estimation)

说明：  行商问题，自动生成最短路径。该算法可以生成经过拓扑每一点一次且仅一次最后回到起点的最短路径。(TSP problem: how to generate the minimal path for a salesman traveling among a set of points.)

基于梳状导频的LS信道估计算法与无信道估计算法性能对比(Performance Comparison between LS Channel Estimation Algorithm and Channelless Estimation Algorithm Based on Comb Pilot)

mimo_ofdm快速时变的一种低复杂度的检测算法在PDF通道，他涉及MIMO-OFDM的基本知识及应用。(Mimo_ofdm fast time-varying a low complexity detection algorithm in PDF channel, basic knowledge and application he relates to MIMO-OFDM.)

说明：  通过labview实现通信信道仿真中的信道估计以及时域均衡，注意这个是以及完整实现了信道的搭建，通过添加时域均衡以及信道估计实现最终的仿真(The channel estimation and time-domain equalization in communication channel simulation are realized by labview. Note that this is to build the channel completely. The final simulation is achieved by adding time-domain equalization and channel estimation.)

In recent years, the number of portable mobile terminal users is increasing with improvement of the wireless communication environment. In addition, mobile multimedia services also bring the increase of wireless traffic and lack of spectrum resources. As a technique for efficient spectrum use, spectrum sharing receives much attention. It dynamically assigns a spectrum channel from a larger area network such as WiMAX to smaller area networks such as WiFi-based wireless LANs and achieves to increase the total wireless communication capacity of this area. In a case where all providers are cooperative, the spectrum sharing can be realized easily and improve user throughput in average. In another case where providers are not cooperative, some spectrum trading methods based on auction theory had been proposed.

WIgner Ville Distribution for time frequency analysis

STM32F103通过串口控制PWM输出(STM32F103 control PWM output through serial port)

易语言 热血世界 游戏的多开程序 请大家批评指正()

利用matlab simulink产生两路模拟语音信号，经过pcm编码、时分复用、DPSK调制经过同一个信道单向传输到对应的接收端。常用的三个模块 simulink、通信模块、信号处理模块。包括课程设计报告。(Using matlab simulink produce two analog voice signals through the pcm encoding, time division multiplexing, DPSK modulation over the same one-way transmission channel to a corresponding receiver. The three modules used simulink, communication module, a signal processing module. Including curriculum design report.)