-
RCS-Radar_Systems_Analysis_and_Design_Using_MATLAB
《Radar Systems Analysis and Design Using MATLAB》中RCS的源程序(matlab program of RCS in《Radar Systems Analysis and Design Using MATLAB》
)
- 2021-04-04 21:59:04下载
- 积分:1
-
26964185
说明: 基于CRAFT的多阶段柔性设备布局优化算法
多阶段设备布局下的总成本包括设备拆装成本、物料搬运成本以及区域利用成本,问题的目标是最小化总成本。首先,在分析问题的基础上,建立基于多阶段设备布局优化目标的数学模型 其次,采用改进的CRAFT启发式算法优化单阶段设备布局 进一步,提出基于单阶段设备布局算法的多阶段启发式算法,优化多阶段设备布局 最后,数值实验表明算法优化后总成本降幅达28.57%.
(CRAFT-based multi-stage flexible equipment layout optimization algorithm under the multi-stage equipment, the layout of the total cost including equipment disassembly cost, material handling costs as well as regional use of cost, the goal is to minimize the total cost. First of all, the analysis of the problem on the basis of the equipment based on the layout of multi-stage mathematical model of optimization objectives Secondly, the adoption of improved CRAFT heuristic algorithm to optimize the layout of single-stage device to further, based on equipment layout algorithm for single-stage multi-stage heuristic algorithm, optimize the layout of multi-stage equipment Finally, numerical experiments show that the optimized algorithm for the total cost of 28.57 percent decrease.)
- 2008-10-17 09:39:38下载
- 积分:1
-
motor
电力电子、电机控制系统仿真模型,包括异步电机及同步电机(Power electronics, motor control system simulation models, including the induction motor and synchronous motor)
- 2012-04-21 10:13:31下载
- 积分:1
-
DSP_MATLAB
关于数字信号处理的matlab程序实现代码,有很多实用的方法,如功率谱估计的算法等等,对学习数字信号处理很有帮助(On digital signal processing matlab program implementation code, there are many practical ways, such as power spectrum estimation algorithms, etc., is helpful in learning digital signal processing)
- 2011-10-03 12:14:04下载
- 积分:1
-
ofdmrrange
说明: 介绍使用matlab对ofdm进行编程,掌握其基本原理(Introduction to program using matlab on ofdm and grasp the basic principles)
- 2011-03-24 19:21:55下载
- 积分:1
-
HW1_2Shooting
Shooting Method for ODE
- 2011-04-20 16:57:40下载
- 积分:1
-
matlab-GM
GM(1,1)源代码,计算原始数据的残差、关联度、小误差概率等。同时画出原始数据和预测数据对比图(GM (1,1) source code to calculate the raw data residuals, correlation, and so a small error probability. At the same time draw the raw data and forecast data comparison chart)
- 2011-10-26 10:14:30下载
- 积分:1
-
Read_nc_files
读取并存储nc文件,不同的文件里的参数可能不一样,按格式修改即可。(Read and store NC files, the parameters in different files may be different, and can be modified according to format.)
- 2018-07-27 18:33:09下载
- 积分:1
-
Filtr_homo
Demo to remove illumination component by homomorphic filtering.
Some functions used here require Image Processing Toolbox and Signal
Processing Toolbox
- 2009-10-19 19:59:54下载
- 积分:1
-
centroid__mse_dist__uq_dist
Matlab的centroid.m、mse_dist.m、uq_dist.m文件 ,它们分别求:一个区域的质心、对已知分布和量化区域边界的均方量化误差、采用均匀量化对一给定信源量化时的失真。(Matlab)
- 2008-05-10 11:02:02下载
- 积分:1