bao-chu-shu-ju

labview 实现声音信号的采集并回放 利用生产者消费者模式(labview s sound acquisition and play back using producer-consumer mode)

labview利用mydaq输出正弦波，三角波，方波(LabVIEW uses mydaq to output sine wave, triangle wave, Fang Bo.)

在嵌入式触摸屏上用LabView开发的转台人机界面操作平台(To use the LabView development turntable human-machine interface operating platform in embedded touch screen on)

说明：  基于LabvIEw的通用自动测试系统(ATs)舍计算机，可鳊程激励、响应数据采集及uuT模块，采用MxI总线控制方式。专用信号发生器为uuT提供模拟激励信号，矩阵开关和适配器完成不同信号间切换。主控计算机执行测试程序，信号发生器发送激励信号，数据采集卡采集数据，采集数据经调理后，并与标准数据|匕较是否满足相应测试结果。(The general automatic test system (ATs) based on LabvIEw can be used as a computer to excite, respond to data acquisition and uuT module. The control mode of MxI bus is adopted. Special signal generator provides analog excitation signal for uuT, matrix switch and adapter complete switching between different signals. The main control computer executes the test program, the signal generator sends the excitation signal, the data acquisition card collects the data, after the data acquisition is adjusted, and compares with the standard data | dagger whether it meets the corresponding test results.)

说明：  for循环判断最大值，最小值。熟悉FOR循环的用法(For loop judges maximum and minimum. Familiar with the use of FOR loops)

说明：  labview基于电脑声卡声音信号采集、分析、处理和存储(LabVIEW is based on the computer sound card sound signal acquisition, analysis, processing and storage)

labview产生波形并显示，对波形图表的曲线控制(Labview generates waveform and displays it, and controls the curve of waveform chart)

基于Labview下 可燃气体浓度监测软件 源码 labview 2010(Based on Labview software under the flammable gas concentration monitoring source labview 2010)

字符串转十六进制的labview源程序vi,可以作为子VI加入到自己的程序中去。(LabVIEW source string to hexadecimal vi, can be used as a sub-VI added to the program to go.)

实现GPIB设备识别列表显示，输出选择的GPIB设备信息，将波形图发送到GPIB接口的示波器设备并显示出来。(For device identification display list GPIB, GPIB output selection device information will be sent to the waveform of the oscilloscope GPIB interface device and displayed.)