hefron

matlab绘制CW信号的时域波形，同时对信号进行频谱分析，并考察采样频率以及信噪比对频谱分析的影响。(matlab draw CW signal time-domain waveform, and spectral analysis of signals and the sampling frequency and signal to noise ratio study of the impact of spectrum analysis.)

matlab code version of network security j

Lorenz系统，吕系统的延迟反馈matlab仿真(Lorenz system, Lu delayed feedback system simulation)

A Good thesis for FSO OFDM Networks with Routing Matlab codes are given

1．通过实验加深对快速傅立叶变换（FFT）基本原理的理解。 2．了解FFT点数与频谱分辨率的关系，以及两种加长序列FFT与原序列FFT的关系。 离散傅里叶变换（DFT）和卷积是信号处理中两个最基本也是最常用的运算，它们涉及到信号与系统的分析与综合这一广泛的信号处理领域。实际上卷积与DFT之间有着互通的联系：卷积可化为DFT来实现，其它的许多算法，如相关、滤波和谱估计等都可化为DFT来实现，DFT也可化为卷积来实现。(1. Deepen the experimental fast Fourier transform (FFT) the basic tenets of understanding. 2. Understand the FFT spectrum and points of the resolution, and two extended sequence with the original FFT FFT relations. Discrete Fourier Transform (DFT) and the convolution of two signal processing is the most commonly used basic arithmetic, they relate to the signal and system analysis and synthesis of the wide range of signal processing field. DFT actually convolution and interoperability between contact : DFT into convolution can be achieved in many other algorithms, If relevant, filtering and spectral estimation could be achieved as DFT, DFT into convolution can be achieved.)

用matlab编程来实现，用HMM模型进行孤立词的语音识别(using Matlab programming to achieve with HMM term isolation of Speech Recognition)

说明：  matlab code for derivation of fundamental solution for plasticity in bem

基于MATLAB内点算法求解SDP半正定规划软件包(MATLAB-based interior-point algorithm for solving semidefinite program package SDP)

國 立 清 華 大 學 碩 士 論 文 符合802.16 標準之通道模擬器之研製(Chapter 1 Introduction Chapter 2 Introduction of microscope effects Chapter 3 Introduction of macroscope and system effects .21 Chapter 4 Channel model simulation Chapter 5 Works before implementing the hardware Chapter 6 Hardware implementation Chapter 7 Conclusions and future directions )

用Simulink中的SimPowersystem完成一个转速、电流双闭环直流调速系统的设计与仿真。采用三相桥式整流，平波电抗器Lp的大小可根据根据仿真调整。给出电机在空载启动，以及在2.5S后加额定负载时转速、电流、电压的变化曲线，并结合调速理论分析这些曲线。(With Simulink in SimPowersystem complete a speed, current double-loop DC speed design and simulation system. Three-phase bridge rectifier, smoothing reactors Lp size can be adjusted according to the simulation. Start the motor load is given, and the speed curve when the rated load after 2.5S, current, voltage, speed and theoretical analysis of these binding curves.)