rayleigh_ofdm

基于MATLAB的牛顿拉夫逊法潮流分析源程序(MATLAB based on the Newton Raphson load flow analysis of source code)

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

对数字基带（频带）传输系统进行仿真，并通过蒙特卡罗误码率仿真方法进行时域、频域分析误码性能。(The digital base-band (band) transmission system simulation, and Monte Carlo simulation method for bit error rate in time domain, frequency domain analysis of BER.)

维也纳科技大学的关于LTE的系统级仿真平台，可以作为初学者使用。(Vienna university of science and technology, the system about LTE level simulation platform, can be used as a beginner)

本代码是关于，运用遗传算法实现旅行商问题的所有代码，以及MATLAB的使用方法以及工具箱等，是你做设计和其他方面的好例子,s是基于MATLAB软件的运行程序(jhjjsdh shdisd sdhjskd sdjdhsjk skdhsj sdhjs hsdh sd sd s s d s sd s d s d s d sd sd s d s d s d s sd s d sd dsd s dds d sd s d d s d s )

canny edge detector in matlab

说明：  matlab 仿真GSM的广播控制信道接收，包括匹配滤波，维特比解调，解卷积，解交织等(matlab simulation of GSM broadcast control channel reception, including the matched filter, Viterbi demodulation, deconvolution, and other deinterleave)

kalman 的算法的MATLAB 的程序以及仿真(kalman algorithm of the MATLAB program and simulation)

【谷速软件】红外与可见光图像自适应融合源代码 ( 在学习过程中作为参考使用)

运用matlab软件，利用遗传算法解决VRP问题( using genetic algorithms to solve the problem of VRP)