Matlab-C-CPP

对几何相似的图像进行相似部分的提取 从而进行分割提取(Similar to the geometry similar to some of the extracted image segmentation to extract)

1.分别在两个图中画出δ(n)和δ(n-2)，其中-10≤n≤10，画出U（n）其中-10≤n≤10。 2.分别在两个图中画出x1(n)=cos(2π×20×0.01×n)，0≤n≤10和x2(n)=(0.8)n，1≤n≤6。 3.由上一题，计算y(n)=x1(n)+x2(n)，并画图。(1. Draw the figure at two δ (n) and δ (n-2), where-10 ≤ n ≤ 10, draw the U (n) where-10 ≤ n ≤ 10. 2. Respectively in the two Draw the figure x1 (n) = cos (2π × 20 × 0.01 × n), 0 ≤ n ≤ 10 and x2 (n) = (0.8) n, 1 ≤ n ≤ 6. 3. from the previous question, calculate y (n) = x1 (n)+ x2 (n), and drawing.)

说明：  里面有三个二维模糊调节器分别实现PID控制器的参数Kp，ki，Kd，的调节。其控制原理：根据前面的偏差e和偏差变化ec将三个模糊控制器FC1,FC2,FC3分别进行模糊化，模糊逻辑推理，解模糊化。最后得到pid控制器参数调节量。(There are three two-dimensional fuzzy controller to achieve PID controller parameters were Kp, ki, Kd, of the regulation. The control principle: According to the previous error e and error change ec the three fuzzy controller FC1, FC2, FC3 were fuzzy, fuzzy logic, defuzzification. Finally, adjust the controller parameters by pid.)

单轮ABS仿真代码，对汽车动力学仿真有参考意义。(Single_whell abs simulation code, will help you on the simulation in auto dynamics)

Power system load flow analysis using NR Power Flow method with implementation of crout algorithm .

Reflection Coefficients for an Air-to-Glass Interface

说明：  双层优化模型，求解思路是：首先对上层的决策变量编码，代人下层规划模型，通过求解下层模型的决策变量值，代入上层模型计算适应度值，然后进行交叉、变异、选择操作，最后求出最优解(two-layer optimization)

利用小波变换对有噪正弦信号进行去噪，来实现信号优化(Wavelet transform denoising of noisy sinusoidal signals to achieve optimal signal)

高功率双包层光纤激光器及仿真,端面抽运的掺Yb双包层光纤激光器的基本理论及其仿真(High power double clad fiber lasers and simulation, end-pumped Yb-doped double-clad fiber lasers basic theory and simulation)

通过对基4快速傅里叶的介绍，使用matlab实现了基4快速傅里叶变化(Through the radix-4 Fast Fourier presentation, using matlab to achieve a base four fast Fourier transform)