2T1RP1T1R

实现了polar在BEC信道下的编译码，画出了误码率图像(The encoding and decoding of polar in BEC channel is realized, and the bit error rate image is drawn.)

提供基本的基于能量检测的频谱感知功能，需要结合软件无线电外设USRP使用(Providing basic spectrum sensing capabilities based on energy detection requires the use of software radio peripheral USRP)

基于MIMO系统原理的stcb，空时编码仿真程序(MIMO stcb)

一个很小和天线计算程序，我觉得非常实用，发上来与大家分享(A very small and the antenna calculation program, I think very useful, the table to share with you)

逆变器主程序 和通讯程序 、中断程序、算法及主要编程代码 希望能够帮助大家(The main program and communication program, interrupt program, algorithm, and main programming code of the inverter are expected to help you)

这是正交空时分组码中使用16QAM调制的源程序(16qam for OSTBC )

这个matlab代码仿真了M-QAM的传输。M的取值不同，调制方式分别为4QAM，16QAM，64QAM等。传输信道为AWGN信道，能出误码率曲线。(The matlab code simulation of the M-QAM transmission. The value of M, the modulation mode of 4QAM, 16QAM, 64QAM. The transmission channel is AWGN, the BER curves.)

DXF轨迹图转G代码，有 直线，圆，圆弧，样条曲线，优化多段线，多段线。与下位机串口通讯！无法编译，是因为要先注册mscomm控件(DXF trajectories turn the G-code, line, circle, arc, spline curves to optimize the polyline, polyline. With lower serial communications! Not compile because the first registered mscomm controls)

MIMO-OFDM系统中的自适应算法中的一种。Chow算法是根据各个子信道的信道容量来分配比特的。与Hughes-Hartogs算法相比，没有了大量的搜素和排序，简化了算法复杂度。(MIMO- OFDM systems in one of the adaptive algorithm. Chow algorithm is based on the channel capacity of each channel to allocate bits. Compared with Hughes- Hartogs algorithm, not a lot of search and sorting, simplify the algorithm complexity.)

完整的Verilog验证模型，包括设备完整的状态。(Complete verilog Verification Model)