radar-signal-processing(matlab)

It is a gui used to zoom a picture or u shrink it. It is very interesting! I hope u will like it!

本函数用于估计固定效应面板空间误差（Panel SEM)模型( computes spatial lag model estimates for spatial panels )

用matlab7.0软件对通信信号进行调制数字通信系统通信系统调制解调(PL_FSK)VHDL建模,包括发送和接受模块PL_FSK(good)

杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ, 最后可得公式如下： ， 最后光强I=4I0cos2（Φ/2）。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)

闪光照相客体重构过程中系数矩阵的计算，构造重构方程。(Radiography reconstruction process object coefficient matrix calculations.)

两种方法实现图像任意角度旋转，原图像的每个像素点寻找在新图的位置，新图中的每个像素点寻找原图中的位置(Two methods for image rotation of an arbitrary angle, each pixel of the original image at the position to find the new graph, the new image for each pixel to find the original position)

基于经验模态分解的信号去噪算法，一个很好的例子(Signal Denoising Algorithm based on empirical mode decomposition)

关于简单的凝视成像的程序，自己编写，希望交流！(Staring imaging procedures, written in the hope that the exchange)

matlab models really useful

添加噪声处理，解耦，恢复原信号，代码里有很完整的注释和解释。( Add noise processing, Decoupling, restore the original signal, )