48Kdrive1

matlab code for view image

Can_1st (CAN Network demonstration with mikroE s CAN module)

带fig界面的matlab图像处理，涉及图像缩放，旋转，加噪去噪等，使用时先点击右下角的开始，才能继续其他操作(Fig interface matlab with image processing, involves image scaling, rotation, noise denoising, etc. When you first click the lower right corner of the start in order to continue other operations)

说明：  一种基于最小类间距的半监督聚类算法，内含注释和测试数据集(a Semi-supervised clustering algorithm based on Single linkage clustering)

很全的matlab 命令集，很不错，共享下。(Very wide of the matlab command set, it is good to share.)

基于双门限比较法的端点检测程序，使用matlab7编写！(Comparison method based on double threshold endpoint testing procedures, the use matlab7 write!)

从倒立摆的数学模型入手，对比了lqr控制器和pid控制器的设计和仿真(From the mathematical model of the inverted pendulum to start, compared to the design and simulation controllers and pid controller lqr)

七自由度整车模型，四个车轮的转动，纵向侧向运动，以及横摆运动，包括dugoff轮胎模型以及其中的参数(Seven degrees of freedom vehicle model, four wheel rotation, vertical lateral movement and yaw movement, including dugoff tire model and parameters which)

matlab常用程序的源代码，以及演示(matlab source code for common procedures, and presentation)

Direct torque control using fuzzy logic controller