dcdc

电池均衡 LTC3300的均衡程序 主动均衡(Battery Balance LTC3300 Balance Program Active Balance)

– 133 条指令 – 大多数可以在一个时钟周期内完成 　　– 32 x 8 通用工作寄存器 + 外设控制寄存器 　　– 全静态工作 　　– 工作于16 MHz 时性能高达16 MIPS 　　– 只需两个时钟周期的硬件乘法器(--133 Instruction- most can be completed in one cycle- 32 x 8 General Purpose Working Registers+ Peripheral Control Registers- Fully Static Operation- Work performance at 16 MHz up to 16 MIPS- only two clock cycle hardware multiply device)

安富莱这个二代示波器无敌牛，建议下下来学习学习！(Anfulei, the second generation oscilloscope, is invincible. It is suggested that we should learn from it.)

ADC0809做的数字电压表，0-5V，4个LED直接接单片机做显示，动态扫描写的驱动(ADC0809 do the figures in Table 0-6 voltage- 5V, 4 LED SCM done directly, dynamic scan was driven)

l利用DSP28335产生三相SPWM正弦波程序(DSP28335 generation of three phase SPWM sine wave program)

说明：  STM32F103的独立看门狗程序实例，非常好用(STM32F103 independent watchdog program example, very useful)

DS1302时钟芯片，MCU STC12单片机 uart显示(DS1302 clock chip, MCU STC12 microcontroller uart display)

说明：  进行速度的测量与监控，具有测速频率高，精度高，反馈效果好等优点(Speed measurement and monitoring has the advantages of high frequency, high accuracy and good feedback effect.)

基于PI控制的电力系统静态无功补偿器Simulink仿真，用于验证控制算法的有效性(STATCOM_Base_on_PIcontrol used to verify the effectiveness of the control algorithm It is achieved by Matlab/Simulink.)

AVR 单片机嵌入式开发源程序，对新手入门有很有帮助。(AVR embedded development program, Getting Started with helpful.)