phase-conversion-coefficient-method

串口发送接收数据。可配置端口，波特率等。 发送可选择ASCII方式或HEX方式。 中断方式接收数据。 可以通过ADC和MCU可以把数据通过 串口直接发送到PC上让MATLAB分析(receiving data. Configurable ports, baud rate, and so on. Send option HEX or ASCII mode. Interrupt receiving data. Through the MCU and ADC data can be sent directly through the serial port to the PC for analysis of MATLAB)

基于Matlab的电力系统短路计算程序，可在一定条件下计算出特定电力系统各支路的短路电流和个节电的短路电压(A program which based by matlab that fucking translation fucking english describ)

实现分时电价模型，削峰填谷，转移24小时一天中用电率，减少谷峰差(Implement TOU model, load shifting, transfer 24 hours a day in electricity rates, reducing the difference between peak and valley)

用于求解Saleh模型，实现对无记忆功放的求解(Saleh model for solving)

artifact removal in ecg

利用matlab编写的 88行拓扑优化代码(topology optimization)

说明：  分别用LMS和RLS算法实现的一个AR4阶谱估计，附源代码和试验结果(LMS and RLS, respectively, with an algorithm AR4-order spectrum estimation, with source code and test results)

这是一个有关语音信号中的噪声降噪的原代码，结果可能有些不好(This is one of the voice signal noise of the original noise code, the result may be some bad)

A simulation of a Control System with COmplex numbers in Gain

Document on demodulating a psk signal