-
77777
this is about smart antennas using matlab
- 2010-08-25 14:27:53下载
- 积分:1
-
chapter5quardshipingnote
这个是matlab中的二次型时频表示的全部代码。(this is the Matlab quadratic time-frequency representation of all the code.)
- 2007-05-09 00:12:42下载
- 积分:1
-
hx711
Arduino hx711库文件,在编写程序省去很大力气,很好用的头文件,大力推荐(Arduino hx711 library files, eliminating the need to write programs in a lot of effort, a good use of header files, strongly recommended)
- 2014-11-09 19:32:57下载
- 积分:1
-
doa_music
利用DOA算法估计来波的数量和角度并画图,算法中待估计的角度数量和大小可调节。(DOA estimation algorithms use the number and angle of wave and drawing, the angle of the algorithm to be estimated number and size can be adjusted.)
- 2014-02-24 08:27:20下载
- 积分:1
-
IS95_baseband_simulation
his packet is a IS-95 baseband simulation for 1 data channel of 9.6 KBps rate.
The simulation is written for static channel and AWGN noise. The packet include:
1) Packet Builder (Viterbi Encoding, Interleaver, PN generation)
2) Modulator (RRC filter)
3) Demodulator (Matched Filter, RAKE receiver)
4) Receiver (HD or SD) (Deinterleaver, Viterbi Decoder).
You should run "Simulation.m" function that include all modules.(his packet is a IS-95 baseband simulation f or a data channel rate of 9.6 KBps. The simulatio n is written for static channel and AWGN noise. T he packet include : 1) Packet Builder (Viterbi Encoding. Interleaver. PN generation) 2) Modulator (RRC filter) 3) Dem odulator (Matched Filter, RAKE receiver) 4) Receiver (HD or SD) (Deinterl eaver. Viterbi Decoder). You should run "Simulation. m "function that include all modules.)
- 2007-03-14 18:36:48下载
- 积分:1
-
example-libmaple-project-master
exemple libmaple project example
- 2015-02-10 21:55:34下载
- 积分:1
-
a
说明: 认知无线电技术的介绍和相关的重要技术,希望能对大家有帮助(Introduction of cognitive radio technology and related technology, we hope to help)
- 2012-11-27 13:14:23下载
- 积分:1
-
chnbound
matlab画中国区域图,可以显示每个省会城市名称(matlab China map, can see city name)
- 2009-11-24 18:13:09下载
- 积分:1
-
fauver
求解fault cover掩盖故障的新方法(A new method for solving fault cover)
- 2011-01-25 13:49:01下载
- 积分:1
-
123426
注水算法是根据某种准则,并根据信道状况对发送功率进行自适应分配,通常是信道状况好的时刻,多分配功率,信道差的时候,少分配功率,从而最大化传输速率。本文运用matlab通过对注水算法在mino系统中的三种不同的情况下进行了仿真,比较出在小信噪比时,相同信噪比下利用CSI的功率注水算法获得容量优于未知CSI的平均功率分配算法;相同容量下已知CSI信噪比比未知CSI时的信噪比小3dB.当信噪比增大到一定程度时,功率注水算法所获得的信道容量将收敛到平均功率分配的信道容量。(Water flooding algorithm is based on certain standards, and according to the channel condition to adaptive allocation of sending power, usually is a good moment, channel situation more distribution power, channel is poor, less power distribution, so as to maximize the transmission rate. This paper USES matlab based on water flooding algorithm in Austin system of three different cases are simulated and compared in small SNR, under the same SNR use CSI power allocation algorithm for capacity is superior to the average power allocation algorithm of unknown CSI Same capacity known CSI signal-to-noise ratio than the unknown CSI small signal-to-noise ratio of 3 db. When the signal-to-noise ratio increases to a certain degree, the power allocation algorithm for channel capacity will converge to the average power distribution channel capacity.
)
- 2013-09-03 20:28:15下载
- 积分:1