scielab_test

用STM32做的FFT以及IFFT程序，MDK开发环境，带有TFT驱动显示程序(STM32 do with FFT and IFFT program, MDK development environment with TFT display driver program)

STM32通过SPI通信控制ADC采集脑电、眼电、心电数据，并将得到的数据通过串口与蓝牙通信后将其发送至PC端进行处理(STM32 collects the data of EEG, eye and ECG through the SPI communication control ADC, and sends the obtained data to the PC side after communication through the serial port.)

This manual discusses modules and peripherals of the MSP430x1xx family of devices. Each discussion presents the module or peripheral in a general sense. Not all features and functions of all modules or peripherals are present on all devices. In addition, modules or peripherals may differ in their exact implementation between device families, or may not be fully implemented on an individual device or device family. Pin functions, internal signal connections and operational paramenters differ device-to-device. The user should consult the device-specific datasheet for these details.

单片机C语言程序设计实训100例——基于8051+Proteus仿真(1(Microcontroller C Programming Language Training 100 cases- based on 8051+ Proteus simulation (a)

说明：  Arduino 对接收到的信号进行解码操作，从而得到按键信息，根据按键值控制舵机。(By decoding the received signal, the key information is obtained and the steering gear is controlled according to the key value.)

基于keil5软件的stm32板的开发，此程序用于串口的初始化，串口发送接收数据并以相应的格式显示出来。(Software development keil5 stm32 board based on this program is used to initialize the serial port, serial port to send and receive data displayed in the appropriate format.)

nec 78k0r csi10 範例程式 ((3-Wire Serial I/O Processing (Master Transmission/Reception, Continuous Transmission/Reception Mode) (Serial Array Unit), C Source))

an active power filter implemented with inverter

l298n控制步进电机两相八拍测试程序，加加加几(l298n controlled stepper motor test program)

赛普拉斯单片机的C语言开发说明，比较适合于刚刚入门的工程师(Cypress MCU C language development that are more suitable for the engineer just started)