TMBP

说明：  在LabVIEW中应用MATLAB进行信号处理(signal processing by matlab in labview!)

Thresholding is a key techniqur for the segmentation and edge detection. this program contained the matlab program for thresholding on the basis of energy entropy of an image.

a var controller is presented.

It is about matlab which depicts brain image segmentation

指纹识别算法的matlab程序，用的算法是gabor滤波器(matlab program of fingerprint recognition algorithm , using the algorithm of gabor filter)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

this source code is an implementation of both primary and secondary user distribution in a predefiened area in Matlab

T-MAC example.tcl TCL code implementation on NS-2 simulation

感应双馈发电机系统的仿真，DC-DC部分采用定功率单环控制，毕业设计有用。( Simulation of doubly fed induction generator system, DC-DC power single-part set-loop control, Graduation usefu.)

说明：  ofdm的同步方法的参考文献，讲述了各种不同的参考文献的方法。(The synchronization method ofdm references about a variety of different methods References.)