1.simulation

H.323.rar 功能的说明H.323.rar 功能的说明

APF的仿真，ipiq检测，希望能帮到大家，相互交流一下心得(APF simulation, ipiq detection, hope to help you, exchange ideas)

说明：   2.wps ：为作业最终的仿真结果与分析 正态分布：.cpp为由C++编写的主程序以获取仿真数据，.txt为存储仿真数据的文档，.m为由matlab根据获取的仿真数据画图的结果，其中1、2、3分别为N（0,1）、N（0,4.26）、N（-2.5,1）的情况 瑞利分布：.cpp为由C++编写的主程序以获取仿真数据，.txt为存储仿真数据的文档，.m为由matlab根据获取的仿真数据画图的结果，其中1、2、3分别为Ray（1）、Ray（0.36）、Ray（3.4）的情况 泊松分布：.cpp为由C++编写的主程序以获取仿真数据，.txt为存储仿真数据的文档，.m为由matlab根据获取的仿真数据画图的结果，其中1、2、3、4分别为Lamda（0.2）、Lamda（1）、Lamda（6）、Lamda（10）的情况 0.m为将三或四种情况画到一副图中并进行仿真结果对比的图像 ((2.wps:) for the job the final simulation results and analysis of the normal distribution:. Cpp written by C++ main program to obtain the simulation data. Txt document for storing simulation data, m grounds matlab drawing according to the simulation data obtained the results, wherein 1, 2, 3 respectively, for the N (0,1), N (0,4.26), N (-2.5,1), of Rayleigh distribution: CPP grounds C++ prepared by the main program to obtain its simulation data, txt for storage simulation data documents, the. m grounds MatLab drawing the results according to the simulation data obtained, wherein 1,2,3 respectively ray (1), ray (0.36), the case of the ray (3.4) poise the loose distribution: cpp grounds written main program C++ to get the simulation data txt simulation data is stored documents, m grounds matlab based on the results of the simulation data obtained drawing, in which 1, 2, 3, 4, respectively 0.m case of Lamda (0.2), Lamda (1), Lamda (6), Lamda (10) of the three or four painting to a graph, )

信号与信息处理——阵列信号处理DOA估计的matlab算法，这是线性调频信号的稀疏分解算法，wigner_will分布(Signal and information processing- array signal processing matlab algorithm for DOA estimation, which is a linear FM signal sparse decomposition algorithm, wigner_will distribution)

本文为基于matlab的粒子群算法的程序，以求函数最小值为例，讲述如何用粒子群算法求得局部和全局最优解。(This article is based on particle swarm algorithm matlab procedures, in order to the minimum function, for example, on how to use PSO obtain local and global optimal solution.)

在matlab上运用有限时域差分法模拟二维光子晶体(the simulation of tm mode in two-dimensional photonic crystals using FDTD)

以最小二乘法进行曲线拟合 得到概率密度函数的参数(With the least squares curve fitting to get the parameters of the probability density function)

二级倒立摆系统采用极点配置的方法控制，系统达到平衡。(Double inverted pendulum control using pole placement method, the system in balance.)

说明：  一个关于matlab进行飞行器仿真设计的文章介绍，希望能为大家提供参考(An aircraft on the matlab simulation design for the article describes, hoping to provide a reference for everyone)

droop control in matlab simulink