Algorithms-for-programmers-ideas-and-source-code

系统分析： O型控制系统的输出 在matlab上可以显示其输出图像(system analysis the graph of output in zero system )

说明：  MATLAB应用环境，适用范围，及应用举例(MATLAB application environment, scope, and application examples)

matlab ppm调制的系统仿真，测试误码率等，用高斯信道来实现。(matlab ppm modulation system simulation, testing, error rate, with Gaussian channel to achieve.)

设计一个一位二进制数大小比较器。比较两个一位二进制数A和B的大小，电路有三个输出端Y1，Y2和Y3，分别对应A大于B，A等于B，A小于B。当条件满足时，相应输出端为1，否则为0。（A，B用两个脉冲源代替），建立仿真模型并保存。(Design a one binary magnitude comparator. A size comparison of two binary numbers A and B, the circuit has three outputs Y1, Y2 and Y3, respectively, corresponding to the A greater than B, A is equal to B, A less than B. When the conditions are met, the corresponding output is 1, and 0 otherwise. (A, B instead of the source with two pulses), and save the simulation model.)

sins+dvl+gps组合导航matlab程序，对于学习导航有一定帮助。(sins+dvl+gps egrated navigation matlab program, it is helpful for learning navigation)

Same functionality as the MATLAB rref function

基于最简单的直接转矩控制的matlab程序框图，经试验，完全可以正常运转(Based on the most simple and direct torque control matlab block diagram, the test, can operate normally)

paper on A Novel Control Strategy for a Variable-Speed Wind Turbine With a Permanent-Magnet Synchronous Generator

在matlab中，实现两幅图的联合相关变换，输出两幅图的联合相关谱。(In matlab, the implementation of two images related to transform United. Figure 2 Output of the joint transform spectrum.)

详细介绍了有限差分法，以及其matlab实现(Details of the finite difference method, and its implementation matlab)