5-chapter

遗传算法的matlab描述，上面有三幅算法结果的图示(Matlab genetic algorithm described above, there are three icons algorithm results)

说明：  使用MATCOM使VC与MATLAB混编的小例子(VC and MATLAB using the mixed MATCOM small example of)

测试样本集对每个模式进行加噪处理，噪声值为±0.1。若网络能对加噪模式进行正确分类，则认为该网络已训练完成。(Test sample set for each pattern plus noise processing, the noise value of ± 0.1. If the network can add noise to the model correctly classified, then that the network has completed the training.)

这是MATLAB宝典的源码，里面包含各个章节的源码，请参考！(This is the MATLAB source code, please refer to!)

prony辨识，广泛应用于电力系统振荡模态辨识，方法简单，辨识精度高(prony identification)

单用户的虚警概率和检测概率的关系，程序正确，简单易懂，值得参考(Single-user relationship probability of false alarm and detection probability, the program is correct, easy to understand, it is also useful)

极化SAR定标处理matlab程序，采用Quegan算法(Polarization SAR processing matlab calibration procedures, the use of Quegan algorithm)

信号与系统实验源代码 包括：实验一 周期信号的谐波逼近，幅频相频分析；实验二 simulink信号的抽样和内插； 实验三 GUIDE二阶状态轨迹的显示；实验四 Wav信号的波形分析及频谱分析(Signals and systems including source code of the experiment: The experiment of a periodic signal of the harmonic approximation, the amplitude-frequency phase-frequency analysis experiment II simulink signal sampling and interpolation experimental GUIDE second-order three-state trajectory display experiment four Wav signal waveform analysis and spectral analysis)

sobel edge detection

MATLAB源码，P0401：用Prewitt算子检测图像的边缘 P0402：用不同σ值的LoG算子检测图像的边缘 P0403：用Canny算子检测图像的边缘 P0404：图像的阈值分割 P0405：用水线阈值法分割图像 P0406：对矩阵进行四叉树分解 P0407：将图像分为文字和非文字的两个类别 P0408：形态学梯度检测二值图像的边缘 P0409：形态学实例——从PCB图像中删除所有电流线，仅保留芯片对象(MATLAB source code, P0401: detection using Prewitt operator Edge P0402: different σ value Log Operators image edge detection P0403: using Canny edge detection image edge P0404: Image Thresholding P0405: water line threshold Image segmentation method P0406: for the matrix quadtree decomposition P0407: the image is divided into text and non-text for these two types of P0408: morphological gradient detected binary image of the edge of P0409: morphological examples- delete images from the PCB All current lines, retaining only the target chip)