LMS_filter

说明：  用双线性变换法设计一个Butterworth低通滤波器，要求其通带截止频率100Hz，阻带截止频率200Hz，通带衰减小于2dB，阻带衰减大于15 dB，采样频率为500 Hz。(Using bilinear transformation to design a Butterworth low-pass filter, requiring that their pass-band cutoff frequency 100Hz, stopband cutoff frequency 200Hz, pass-band attenuation is less than 2dB, stop-band attenuation greater than 15 dB, a sampling frequency of 500 Hz.)

线天线阵和面天线阵在MATLAB内的方向图以及半功率带宽(Antenna array and antenna array within the orientation map in MATLAB and the half-power bandwidth of)

HFSS/UTD混合法计算电大尺寸导体上的天线(HFSS/UTD hybrid method to calculate the antenna on a large conductor)

一种改进型的PSO的机器学习算法实现，应用欧氏距离作为分类便准，KNN分类法实现分类(An improved PSO algorithm)

利用x(n)=Asin(pi*n/16)+z(n),z(n)为mean=0，var=0.1高斯白噪声，x(n)的SNR为10dB,s(n)=Asin(pi*n/16-5*pi),得出了x(n)和s(n)互相关函数r(n)，以及二者的卷积和.(The utilization for the mean of x (n) = Asin (pi* n/16)+ z (n), z (n) = 0, var = 0.1 Gaussian white noise, x (n) is the SNR as 10dB, s (n) =Asin (pi* n/16-5* pi), draw the x (n) and s (n) the cross-correlation function r (n), as well as the convolution of the two.)

说明：  把2D图形变为3D图像的软件。先用该软件将2D图像转为数据，再用我上传的将2D转为3D的MATLAB软件绘图即可。(2D into 3D software)

用于检测两个信号的延时情况,应用方面非常广泛(for detecting signal delay, the application is very extensive)

this file desribe the propagation of mode in few mode fiber

matlab一般常用功能都有详细的源码，可供初识matlab的学者使用(matlab commonly used functions are detailed source for scholars to use matlab acquaintance)

This is the file for direct static var compensator in conventional model