code

利用K近邻法实现数字识别算法。误差小，识别效率高，网络训练速度快。(K-nearest neighbor algorithm, digital identification algorithm. Error is small, high recognition efficiency and speed of network training.)

this programmedefine a circuit-based simulation model for a PV cell in order to allow find MPPT

PMSG网侧的结构包括逆变器、PWM发生器、电压矢量控制。采用电压外环和电流内环的双闭环控制。设计电流控制器时，希望稳态电流无静差，而且动态要求上，永磁直驱风力发电系统中不允许在电流调节过程中有太大的电流超调.(PMSG network side structure includes an inverter, PWM generators, voltage vector control. Using a voltage outer and inner current double closed loop control. Design current controller, hope no static error steady-state current, and the dynamic requirements, permanent magnet direct drive wind power system does not allow much of the current overshoot in the current regulation process.)

说明：  documents for power engineering research work

此算法先把伤病人员进行特殊对待，在计算出其他人的入院日期，表二的出院日期为 统计的期望值 运用是要改变 数据的初值 和u值（数据录入个数）；(This algorithm first special treat the sick and wounded, in the calculation of other people' s admission date, discharge date in Table II used for the statistical expectation is to change the initial data and u values ​ ​ (the number of data entry) )

说明：  good code in matlab pro

利用lms自适应滤波器原理，实现波束形成。 波束形成器的零干扰容量随着迭代次数和干扰目标信号比的增大而改善。(Lms adaptive filter using the principle to achieve beamforming. Beamformer with the zero-interference capacity of the number of iterations and the target signal interference ratio increased to improve.)

数据的规范化程序，消除数据的量纲对处理结果的影响。数据点之间距离的计算程序。(Data standardization process, eliminate data on the processing results of the dimensionless)

syndicate form for pro.nary exams

Matlab/Simulink OFDM 64 QAM Module