DBMS

说明：  matlab7.0基础教程 清华大学 经典教材 快速入门 学习资料(matlab7.0)

The following Matlab project contains the source code and Matlab examples used for inpainting (coherency sensitive hashing). This submission provides image inpainting using coherency sensitive hashing (CSH).

本文通过对当前实时控制的应用研究，提出了将离线仿真与实时控制有机结 合起来，利用MATLAB实现对直线单级倒立摆实时控制的思路。经过分析比较， 确定了基于MATLAB的Real-Time Windows Target实时内核开发硬件驱动程序 的实时控制方案，将Simulink生成的仿真模型下载到目标实时内核中运行，驱动 外部硬件设备，实现对倒立摆的控制。文中介绍的在Real-Time Windows Target 实时内核环境中开发第三方设备驱动程序的方法，是构建本实验平台的核心技术 之一，具有普遍适用性，有一定的推广价值。(Based on the current real-time control of the applied research, raised offline simulation and real-time control organically combined to realize the use of MATLAB linear single-stage inverted pendulum idea of real-time control. After analysis and comparison, to determine based on MATLAB)

simulation of 3_phase rectifier in matlab simulink

用SLM方法来减小OFDM系统的PAR，给出在不同的M值下，系统的PAR曲线图。(To reduce the use of SLM OFDM system PAR, gives the different values ​ ​ of M, the system PAR of Fig.)

This paper presents a new synchronous-referenceframe (SRF)-based control method to compensate power-quality (PQ) problems through a three-phase four-wire unified PQ conditioner (UPQC) under unbalanced and distorted load conditions. The proposed UPQC system can improve the power quality at the point of common coupling on power distribution systems under unbalanced and distorted load conditions.

说明：  基于matlab中的simulink，进行16QAM的仿真搭建。包括了基带信号发生器，串/并模块，模块1，载波调制模块，高斯白噪声信道，模块2，误码率计算器等，能够较好地实现16QAM的调制解调。(Based on the Simulink of MATLAB, the simulation of 16QAM is built. It includes baseband signal generator, serial / parallel module, module 1, carrier modulation module, Gaussian white noise channel, module 2, bit error rate calculator and so on. It can achieve 16QAM modulation and demodulation well.)

matlab 卡尔曼跟踪，可以很好的跟踪到小球(matlab kalman)

AirSWOT JPL s Earth Science Airborne Program scacacascassssssssssssssssca

用于产生Frank多相编码复数序列，然后将得到的编码做相关(generate code and make it throngh matched filter)