登录
首页 » matlab » Hough

Hough

于 2015-03-10 发布 文件大小:2KB
0 326
下载积分: 1 下载次数: 4

代码说明:

  数字图像处理方面,利用HOUGH变换检测图像中的直线,中间设计多方面有加噪声也有滤波。(Digital image processing, use HOUGH transform to detect straight lines in an image, there are many middle-plus-noise design also has filtering.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • RHC
    介绍了RHC控制算法的实现,有具体的例子(Introduced the RHC control algorithm, there are concrete examples)
    2010-07-07 15:54:41下载
    积分:1
  • 604150548
    该方法适用于解决阶数比较大的线性方程组,从理论上讲这种方法是收敛的,而且具有较好的可操作性(this method is suited for some complex equation)
    2010-11-19 10:45:22下载
    积分:1
  • Bus-suspension-control-in-matlab
    bus viberation in matlab codes
    2015-02-08 02:31:45下载
    积分:1
  • Staxen_Adaptive-Modulation
    a power point tutorial demonstrate adaptive modulation
    2014-03-16 14:09:39下载
    积分:1
  • ha_dong_pingjun_lmd-
    lmd 采用滑动平均处理,调整过,可以直接运行出图。(lmd hua dong pingjun)
    2020-11-19 20:39:41下载
    积分:1
  • F2P_V0.8
    说明:  采用FDTD计算2维光子晶体的散射和透射的可执行程序小软件(Calculated using FDTD 2-D photonic crystal scattering and transmission of the executable program small software)
    2010-04-18 16:24:06下载
    积分:1
  • UWB-antenna-for-time-domain-analysis
    带有三个频率循环的UWB天线的时域分析程序(UWB antenna for time domain analysis)
    2013-08-09 22:35:31下载
    积分:1
  • 卡尔曼滤波法
    某火箭在空中沿直线做匀加速飞行,加速度为 ,发动机推力的波动一定会引起加速度波动,雷达以间隔时间不断测量该火箭距离远点的距离 ,由于雷达的测量噪声使得火箭距离测量值 中含有噪声。现在欲通过雷达对火箭距离的测量数据求得火箭的真实距离、速度和加速度。(A linear constant acceleration rocket flight in the air along the acceleration, the engine thrust fluctuation will cause the fluctuation of acceleration time interval measurement, radar to constantly the rocket from the far point of the distance, because the noise radar makes the rocket range measurements with noise. Now, the real distance, velocity and acceleration of the rocket are obtained by measuring the distance of the rocket by radar.)
    2020-12-25 15:49:04下载
    积分:1
  • re1
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:51:25下载
    积分:1
  • xinhaojiancw
    信号检测与估值实验报告,写的很好哦,本人花了大量的时间(Signal detection and valuation lab report, oh well, I spent a lot of time)
    2013-03-02 15:04:53下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载