fgd785687

LCL闭环控制系统的设计方案，可用于光伏系统和MATLAB建模(LCL closed-loop control system design can be used for photovoltaic systems and MATLAB modeling)

说明：  3) 跨平台文档结构的调整 项目文档是始终贯穿着整个系统的，但由于Windows系统与其他系统如Linux等的文档结构不同，项目的可移植性将会受到限制，因此强调可移植性的本系统中跨平台文档结构的调整是必不可少的，我们预计在这一阶段以Windows 和 Linux为基础出2套相应的代码版本，基础代码部分不变，只是在文档接口及对应的应用工具上做出相应的选择。预计所需时间为二个月，包括平台的移植，接口的研究和开发等(3) cross-platform document the restructuring of the project document is always run through the whole system, but the Windows system and other systems such as Linux and other documents of different structures, the project will be subject to the portability restrictions of the emphasis on portability cross-platform file system structure is essential, we expect at this stage in Windows and Linux based on the 2 versions of the corresponding code, the basis of some of the same code, but in the document application interface and the corresponding tools choices accordingly. Expected time required for months, including platform migration, interfaces, such as research and development)

光纤射频传输系统中相干正交频分复用的研究，介绍了系统的结构和性能,是一份很不错的学习材料。(Coherent optical fiber radio transmission system using orthogonal frequency division multiplexing, introduces the system structure and performance, is a very good learning materials.)

介绍了经典的时频分布和检测理论的同时，作者利用时频分布的方法，将一 维时间信号转化到二维的时频空间中，通过提取图像的特征来判决信号和杂波， 采用的数据是使用McMaster IPIX雷达，在加拿大东海岸附近测得的。实测数据 研究表明此方法可以得到很好的检测结果。 (In this paper,we first review the time-frequency analysis and time -frequency-based detection methods.Secondly,by analyzing a mass of the measured data of sea clutter,we show the difference of time-frequency geometric features between echoes with a target and pure sea clutter.Finally,we given the detection algorithm based on the time-frequency geometric features.The results of the measured data show that the proposed method can effectively find low-velocity small targets in sea clutter.This approach is a novel try to detect small targets in sea clutter.)

PHOTOLITIOGRAPHY( desigining and layout of cmos)

较详细的论述了IPM模块的驱动及保护电路 (More detailed discussion of the IPM module driver and protection circuits)

用GAL16V8设计可变长度序列信号发生器，在掌握伪随机序列性质的基础上，设计给定长度的伪随机序列信号发生器，也即设计给定n后（n为移位寄存器的级数）最长线性反馈移位寄存器序列。并在给定n产生的最长序列的基础上，截短出课题给出的序列长度，并用FM软件对可编程器件GAL16V8进行编程，以实现长度不同的序列信号发生器。(GAL16V8 design variable-length sequence signal generator based on the master pseudo-random sequence nature, the design of a given length pseudo-random sequence Signal generator, designed for the series) up to linear feedback shift register sequences given n (n is the shift register. And given n Sequence length given by the subject on the basis of the longest sequence, truncated, and FM software for programming the programmable device GAL16V8, in order to achieve Different length of the sequence signal generator.)

基于 Simplorer /MATLAB 的多电飞机环控系统研究 基于Simplorer_Maxw_省略_l的多电飞机机电驱动系统仿真研究 基于SIMPLORER的电源电路仿真_李傲梅 装甲车辆电源系统Simulink与Simplorer联合仿真_康洪铭(Study on Environmental Control System of More Electric Aircraft Based on Simplorer /MATLAB)

三电平载波PWM谐波分析及LCL滤波器设计(Three-level PWM carrier harmonic analysis and LCL filter design)

此程序是为工控设备增加温度和时钟显示电路源程序。(This program is for industrial equipment increased temperature and clock display circuit source.)