Reconstruction-algorithm

本程序为求矩阵的最大特征值、全部特征值和特征向量，应用乘幂法和雅可比过关法(This procedure for the sake of the largest eigenvalue matrix, all eigenvalues and eigenvectors, applications by a power law and the Jacobi clearance method)

　提高电源的动态响应　　非线性和复杂的系统是一个转换器　　电力电子的有趣的挑战。摘要介绍了　　设计和实现数字PID控制器使用　　混沌粒子群优化(复)提振　　转换器,提出了自动调优转换器的方法　　最优启动响应。当系统启动时,处理器　　单元分析了开环启动响应转炉和　　在一些迭代使用复准备最佳反应　　算法。使用逻辑映射混沌映射序列　　增加它的收敛速度和精度。模拟　　和实现结果显示提出的效率　　方法(Improving dynamic response of DC-DC converters which are nonlinear and complicate systems is an interesting challenge in power electronics. This paper presents the design and implementation of digital PID controller using the chaotic particle swarm optimization (CPSO) for a Boost converter and proposes an approach for auto tuning converter optimum startup response. When the system starts, processor unit analyses the open loop startup response of converter and prepares optimum response during some iteration using CPSO algorithm. Chaotic mapping using logistic map sequences increases its convergence rate and resulting precision. Simulation and Implementation results show efficiency of proposed approach)

利用ITU656接口传输数据流的方法!已得到应用!(ITU656 interface transfer data streams using the method! Has been applied!)

说明：  LDPC编码的BP译码算法的matlab程序(Matlab Program of BP Decoding Algorithms for LDPC Coding)

完成输入序列的msk调制功能，输入序列必须是0 1(Complete input sequence of msk modulation, the input sequence must be 01)

this document speaks about optcal fiber transmission

设计巴特沃斯低通和高通IIR数字滤波器，得到二阶频率级联参数(Design of Butterworth low-pass and high-pass IIR digital filters, to be cascaded second-order frequency parameter)

这是一个基于MATLAB与VC混合编程的程序代码!是关于一维离散小波去噪的程序!(based on MATLAB and Visual C++ programming code! On the one-dimensional discrete wavelet denoising the procedure!)

EXAMPLE OF ADAPTIVE FUZZY CONTROLLER

加窗离散傅立叶变换，用DFT对离散信号进行谱分析，通过选用不同的加窗函数来抑制信号截断造成的频谱泄漏(windowed discrete Fourier transform, DFT right discrete signal spectral analysis, the increase in the alternative window function to curb the disconnect signal leakage spectrum)