-
元胞自动机 fuibui
用蒙特卡洛模拟的方法计算美式期权的价格以及基本描述,matlab编写的元胞自动机,完整的图像处理课设,包含所有源代码,汽车图像。( Monte Carlo simulation method of calculating the American option price and basic description, matlab prepared cellular automata, Complete class-based image processing, contains all of the source code, auto image.)
- 2016-11-15 11:48:30下载
- 积分:1
-
源程序-Matlab仿真及其在光学课程中的应用1
说明: matlab 在光学课程中的仿真应用源码(application of matlab in optical simulation)
- 2020-06-01 16:09:43下载
- 积分:1
-
SinteseHInfContinuo
buggy code for Hinf design with pole placement constrains in matlab
- 2013-03-23 03:42:04下载
- 积分:1
-
tde
几种时延估计算法,包括广义相关法,二次相关法,循环谱相干法等(Time delay estimation of cyclic cross-correlation method, based on steady signal cycle characteristics of several time delay estimation algorithms, including the generalized correlation method, quadratic correlation method, cyclic spectral correlation method, etc)
- 2016-06-29 20:32:13下载
- 积分:1
-
tuxiangtuihua
图像锐化功能,基于梯度算法的~可以插入其他程序(Image sharpening, based on the gradient algorithm ~ can be inserted into other programs)
- 2011-05-24 19:39:55下载
- 积分:1
-
rgbhist
conversion of image from RGB to HIST
- 2011-06-04 22:36:56下载
- 积分:1
-
triangetry
一种光滤波器仿真设计.具有一定局限性.通过先行缔造滤波器频谱图,进行设计仿真(Simulation design of an optical filter has certain limitations. Plan first to create a filter spectrum, to simulate the design)
- 2012-05-25 00:21:56下载
- 积分:1
-
项目4
说明: 任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。
要求:
1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。
2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。
3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify.
Requirement:
1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km.
2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm.
3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
- 2019-05-13 09:39:41下载
- 积分:1
-
Monte-Carlo-method
基于蒙特卡罗方法的试卷难度分布研究,Monte Carlo method based on the difficulty of distribution of papers(Monte Carlo method based on the difficulty of distribution of papers)
- 2013-09-11 08:03:26下载
- 积分:1
-
rozwi_zania
fibonacci - algorytm matlab(fibonacci- algorytm matlab)
- 2009-05-03 00:37:57下载
- 积分:1