Energy-Detection

说明：  内容为《MATLAB图形图像》用到的部分程序,希望对大家有帮助!(some examples of the use of matlab)

这是 OFDM系统的Park&Cheon定时同步和Schmidl&Cox定时同步。(This is the OFDM system Park&Cheon timing synchronization and timing synchronization for Schmidl&Cox.)

高等光学仿真原程序，里面有光纤波导激光原理等(Advanced optics simulation of the original program, which has fiber waveguide laser principle, etc.)

说明：  程序主要实现了三次样条插值，程序注释很详细(It mainly implements cubic spline interpolation with detailed program annotations.)

Transient Overvoltage in Power System

三相光伏逆变并网的仿真，本科毕设要求参见标准测试模型，自写曲率计算函数 。( Three-phase photovoltaic inverter and network simulation, Undergraduate complete set requirements refer to the standard test models, Since writing the curvature calculation function.)

给定初始值，产生费根鲍姆迭代轨迹，logistics映射，周期点等程序(Given initial value, resulting in iterative trajectory Feigenbaum, logistics map, periodic points and other procedures)

用kalman滤波算法仿真实现2自由度机器人对目标的跟踪（demo2忽略了Jt，demo3包含可Jsita和Jt，估计总雅可比矩阵J的kalman滤波）---机器人视觉伺服(Simulation kalman filter algorithm with 2 degrees of freedom robot target tracking (demo2 ignored Jt, demo3 contains Jsita and Jt, the total estimated Jacobian matrix J of the kalman filter)--- robot visual servo)

基于灰色关联理论的移动机械人故障诊断方法研究(Based on Grey Relational Theory mobile robot fault diagnosis method)

Three-phase electric power is a common method of alternating-current electric power generation, transmission, and distribution.[1] It is a type of polyphase system and is the most common method used by electrical grids worldwide to transfer power. It is also used to power large motors and other heavy loads. A three-phase system is usually more economical than an equivalent single-phase or two-phase system at the same voltage because it uses less conductor material to transmit electrical power.[2] The three-phase system was independently invented by Galileo Ferraris, Mikhail Dolivo-Dobrovolsky and Nikola Tesla in the late 1880s.