-
mfcc
说明: 这是个基于matlab环境下,提取mfcc参数的小程序,希望能对大家有帮助。(This is a matlab-based environment, the applet parameter extraction mfcc, hoping to be helpful.)
- 2011-02-24 17:27:24下载
- 积分:1
-
changweifen
说明: 几个matlab解常微分方程的例子:验证齐次方程有形如1/(xM+yN)的积分因子;全微分方程;求方程的显式解和绘图;解出x的隐方程的解法;方程的隐式解(Several examples of matlab Ordinary Differential Equations: Homogeneous Equation physical verification, such as 1/(xM+ yN) of the integral factor the whole equation the explicit solution of Equation and drawings solve the implicit equation x Solution equation the implicit solution)
- 2011-04-17 11:48:14下载
- 积分:1
-
gpskf
使用卡尔曼滤波对加了噪声的GPS定位数据进行滤波。(Calman filtering is used to filter the GPS location data with noise.)
- 2017-11-09 21:33:23下载
- 积分:1
-
Rapid-Acquisition-of-Doppler-Shift-
本文提出了一种适用于低轨卫异扩频通信系统的多普勒频移快捕方法.该方法基于数字匹配滤波器及自动频率控制环路_利用数字匹配滤波器的囚码快捕特性及其输出主相关峰值对频偏的敏感性,缩短多普勒频移的
捕获时间.论文首先推导了多普勒频移的平均捕获时间表达式,然后根据数值分析结果得到了准最佳捕获判决策略,最后通过比较验证了该快捕方法相对于传统串行捕获方法在性能上的提高.
(This paper presents a low-orbit health for different spread spectrum communication system fast catching the Doppler shift method, which based on digital matched filter and automatic frequency control loop _ prisoners using digital matched filter code features rapid acquisition and the output of the main correlation peak frequency deviation of the sensitivity of the Doppler frequency shift to shorten acquisition time. paper first derive the mean Doppler shift acquisition time expression, then the numerical results obtained quasi-optimal capture decision strategies, and finally verified by comparing with the rapid acquisition method to capture the traditional method of serial improvement in performance.)
- 2011-10-22 19:35:00下载
- 积分:1
-
KalmanFilterWay
卡尔曼 滤波 去除噪声 测定俯仰角 方位角 距离 等等(kalman filter)
- 2016-12-27 14:46:30下载
- 积分:1
-
export_fig
exporting anit aliased images
- 2010-07-20 05:55:24下载
- 积分:1
-
ASP_ForwardSpatialSmoothing
阵列信号处理,前向平滑
原创啊。。。。。。。(Array signal processing, prior to the smooth original ah. . . . . . .)
- 2010-10-30 09:42:28下载
- 积分:1
-
clark
自己建立的clark变换模块,根据TI公司永磁电动机例程编写(clark transform model created by myself, based on TI s permanent magnet motor routine)
- 2012-04-09 14:55:22下载
- 积分:1
-
rcos_dsp
升余弦滚降系统的源程序(用于调制解调系统中波形成型)(Raised Cosine system of the source (for modulation and demodulation waveform prototyping system))
- 2007-05-11 16:32:19下载
- 积分:1
-
ReadFID
该程序是一个较简短的程序,主要读取磁共振fid信号,显示波形(The program is a relatively short procedure, the main reading magnetic resonance fid signal waveform display)
- 2013-11-06 08:53:02下载
- 积分:1