solar

Creates a package named XPLAN as a wrapper over DBMS_XPLAN

carlight1中是一个用C编的程序，用于计算每条光线在测试屏上的坐标(carlight 1 is a C series of the program, each ray is used to calculate the coordinates on the screen in the test)

Matlab simulink radar

matlab中如何进行卡尔曼滤波器建模 (it is writtenn by me..you must understand)

To Encode the image data and compressed with important data of image

uwb无线电基础代码，第八章，超宽带信道与接收机，共四个程序。(based on UWB radio code, Chapter VIII, ultra-wideband channel with the receiver, a total of four procedures.)

CLP Interface to LP/QP solver MEXCLP

Image Enhancement using pixel information

电源控制环路设计英文课件电源控制环路设计英文课件

DTW算法的程序，申请两个n*m的矩阵D、d,分别为累积距离和帧匹配距离。这里n和m为测试模版与参考模版的帧数。然后通过一个循环计算两个模版的帧匹配距离d。接下来进行动态规划，为每个格点 （i，j）都计算其三个可能的前续格点的累积距离D1，D2，D3。考虑到边界问题，有些前续格点可能不存在，因此加入一些判断条件最后利用最小值函数min()，找到三个前续格点的累积 距离作为累积距离，与当前帧的匹配距离d（i，j）相加，作为当前格点的累积距离。该计算过程一直达到格点（n，m），并将D（n，m）输出，作为模版匹配的结果。(DTW algorithm procedures, apply two n* m matrix D, d, respectively, accumulated distance and frame matching distance. Where n and m is a reference test pattern and the template frames. Then through a loop to calculate two frames template matching distance d. Next, dynamic programming, for each grid point (i, j) are calculated from the cumulative D1 before the renewal of its three possible lattice point, D2, D3. Taking into account the boundary problem, some former continued grid point may not exist, so add some conditions to determine the final use of the minimum function min (), found three former continued accumulation of grid points cumulative distance as the distance from the current frame to match the d (i, j) added, and a current cumulative distance grid. This calculation has reached the grid (n, m), and D (n, m) output, as a result of template matching.)