REBEL-GOGNJUXIANG

基于免疫算法的tsp问题的matlab程序 (Based on Immune Algorithm tsp problem matlab program)

simulation of tapped inductor buck converter type 1 for led emission

This project simulates the operation of wireless digital communications using Q-PSK and 8PSK modulator. The project consists of four steps: transmitter design, channel propagation effect, receiver design and finally measuring system performance.

说明：  本目录主要包括：文档和两个源代码。 其中一个源代码是识别程序的，另一个是一个矩阵类库的，书里面也使用过，所以一并附上。 因为已经保存了训练好的网络权值，所以第一次使用识别程序时，可以直接运行\\Release目录下的可执行文件，然后对图片目录中的测试图片进行读入、识别。 当然读者也可以自行用训练样本训练网络，不过要特别注意训练样本的选择，否则可能造成识别率很低。训练样本选择的原则是，尽可能的有代表性，在训练时间不至于太长的情况下，训练样本数目尽量多。 ( This directory includes: documentation and two source code. One of the source code is to identify the procedure, the other is a matrix class library, the book which is also used, so be attached. Because it has saved the trained network weights, so the first use of identification procedures, you can directly run \ \ Release directory of the executable files, and then tested on the images directory to read pictures, identification. Of course, readers are free to use the training samples to train the network, but pay special attention to training samples, otherwise it may cause very low recognition rate. Training sample selection principle is that as far as possible, representative, in the long training time Buzhi Yu s case, the number of training samples as much as possible. )

《MATLAB简明教程》俺买的最新版的MATLAB教材，相当权威的，你绝对下不到更好的 了("Concise Guide to MATLAB," I bought the latest version of MATLAB materials, authoritative, you definitely less than the better)

The above file show the Independent componets analysis used in face recognisation

三相异步电机的控制；电压源逆变器，采用电流滞环控制；典型的异步电动机按转子磁链定向的矢量控制，磁链与转矩实现解耦。(Three phase induction motor control voltage source inverter, the current hysteresis control the typical asynchronous motor by rotor flux oriented vector control, flux linkage and torque decoupling. )

Simple code to learn how to code a Kalman Filter in Matlab

source input for RAKE

在matlab画图时 能增加两条数据指针 方便读取数据(put data cursors on your plots)