testYourComputer

使用MATLAB对特定信号做短时傅里叶分析的源码，修改方便(The use of MATLAB to do a specific short-time Fourier analysis of the signal source, modified to facilitate)

说明：  MATLAB中应用的混沌时间序列分析的1.0版本(Application of MATLAB in the analysis of chaotic time series version 1.0)

说明：  有关 信道编译码的源代码等等等 (The relevant channel codec, such as source code, etc.)

image segmentation using matlab

说明：  仿真实现噪声调幅干扰信号,信号形式为一般形式，其中包含(simulation of noise moding jamming signal)

大功率分布式发电系统通常采用三相逆变器并网，由于三相逆变器系统参数耦合，传统方法设计的控制器算法复杂。在d。q坐标系下为双模式三相并网逆变器的独市和并网模式建立了数学模型．采用新的解耦方法，依据独立和并网模式控制系统超调量越小，模式切换过程中被控量的波动越小。切换过程就越平滑的原则。完成了两种模式的控制器设计，即分别应用积分环节、比例环节即可将独立模式和并网模式整定成典型的二阶系统，控制器设计简单．能取得优良的动、静态特性。仿真与实验验证了设计方法的正确性和可行性。(It is necessary to research on three—phase grid-connected inverter which a8 an important part of distributed generation．The parameters of three—phase inverter are coupling．The traditional design algorithm of the controller is complicated．The mathematicM models of stand—alone mode and grid—connected mode are established in d，q fhme． Based on the principle that the lower overshoot of the controller system，the smaller fluctuation of the controlled vailables， the smoother in transfer，controllers of two modes are designed separately，as integral and proportional regulators are separately added to stand-alone mode and g而d—connected mode．The controller has good dynamic and static char— acteristics．Simulation and experimental results varify the correctness and feasibility of the proposed method．)

This file contains a C++ based source code for an optimized Viterbi decoder.

Empirical Mode Decomposition

OFDM正交频分复用程序...对于初学者很有帮助 (OFDM Orthogonal Frequency Division Multiplexing procedures for beginners helpful ...)

The 16x2 LCD Display requires a specific startup sequence // to initialize itself. This sequence (1) clears the display, // (2) moves the cursor to home, (3) resets the function code // (4) turns the display on, and (5) sets the entry mode