example-a-function-for-chap2

编写一个含QAM传输的发送和接收模块 1)分别采用复基带仿真和实带通仿真两种形式 a) 实带通仿真时, 载波频率为符号率的4倍 b)发端采用滚降系数0.5的根号升余弦滤波器 2)画出Eb/N0=15dB时的接收波形(收滤波前),取100个采样 3)画出发端输出的眼图和收端过匹配滤波后的眼图(画眼图时不加噪声) 统计误符号率和误比特率与Eb/N0的关系,画出曲线, 与理论计算的曲线相对比 (Prepare to send of one with QAM transmission and receiver module 1), respectively, the complex baseband simulation and the real band-pass simulation in two forms a) the real band-pass simulation, the carrier frequency used for the symbol rate of 4 times b) the originator roll-off factor of 0.5 root raised cosine filter, 2) draw Eb/N0 = 15dB when the received waveform (closing filter), take 100 samples) to draw the originator of the output eye diagram and income side of the eye diagram after the matched filter ( draw the eye diagram without noise) statistics symbol error rate and bit error rate and Eb/N0, draw a curve calculated with the theoretical curve compared)

波束空间MUSIC算法（music算法中的一种），对多个不同方向的信号进行入射角估计，里面包含了m文件、理论推导、仿真结果以及相关讨论。(Beam space MUSIC algorithm (a) the music algorithm, a number of different directions, the signal of the angle of incidence is estimated, which contains m documents, theoretical analysis, simulation results and related discussions.)

Trajectory generation program using several methode of planification tapezoidel, bang -bang method

高斯法用于IEEE30节点系统的潮流计算源代码(Gauss law for the IEEE30 bus system source code flow calculation)

求解曲线或者光谱等等的峰值，matlab完整程序。(Solving the curve or spectral peak Matlab complete program.)

this will u in HSPICE tools

this is coding of dwt in matlab

Blackman window filter programs

元胞自动机 nasch 模型！单条道路上模拟 的(a cellular automaton，nasch model on one lane)

最大流和最小截算法，在这个函数的编制中存在一个细节，当任取一个已标号未检查的点的时候，我取的最靠前的点。如果加进随机选取的语句，每次运行程序可能会出现不同的最大流结果。(Maximum flow and minimum cut algorithms, in this function exists in the preparation of a detail, if any label does not take a check point has been, I get the most front point. If the statement is added to randomly selected for each run the program may come up with different results of maximum flow.)