xingtaixuedaima

模型参考自适应系统的simulink文件(The simulink File of the model reference adaptive system)

journal one for the UPFC voltage profile and power measurement

说明：  利用盲源分离分离混合信号，此算法为FastICA,运行稳定(Separation of mixed signals by blind source separation algorithm)

toolbox 4 的说明文件,对新手可能有用 。(toolbox 4 describe)

sttc，stbc blabst等的编码(sttc stbc)

基于正交分量的OMP稀疏分解参考程序，要求分解信号分量具有正交性(Sparse orthogonal decomposition OMP component reference procedure that requires the signal components with the orthogonal decomposition)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

algorithme to conversion level coleur to gris

非常好用和实用的直线拟合MATLAB小程序。(Very easy to use and practical linear fitting MATLAB applet.)

用于解算一维非线性平流扩散方程的半隐式差分格式算法(Computing the numerical solution of nonlinear advection equation via a semi-implicit scheme. )