matlabcanrecord

Sobel, Prewitt, roberts edge detection implemented by matlab

用MALLAT算法对信号分解,并给出各分解信号的频谱(with MALLAT right signal decomposition algorithm, and gives the signal decomposition of the spectrum)

The BCJR algorithm is an algorithm for maximum a posteriori decoding of error correcting codes defined on trellises (principally convolutional codes). The algorithm is named after its inventors: Bahl, Cocke, Jelinek and Raviv.[1] This algorithm is critical to modern iteratively-decoded error-correcting codes including turbo codes and low-density parity-check codes.

主轴有限元分析临界转速及刚度、阻尼与模态振型。(Finite Element Analysis Critical spindle speed and stiffness, damping and mode shapes.)

说明：  GM（1，1）灰色预测模型预测发展趋势，并确定模型的精确合格度(GM (1,1) gray prediction model predicts the development trend and determines the accuracy of the model)

说明：  本程序运行需一个小时左右。优化准则是旁瓣电平最小。取栅格间距为lemda/2,阵元间距为栅格间距的整数倍。放阵元的位置放1，否则放0(This program should be running an hour or so. Rule of optimization is side-lobe level minimum. Take grid spacing for lemda/2, spacing for grid spacing array (integer times. Put the position of the array (put 1, otherwise put 0 )

MPC在Matlab上的使用，包括有约束和无约束(The useage of MPC on Matlab,and it includes constraints and no constraints)

数据包络的程序，解决多目标决策，程序中有部分正文的注释，很适合初学者使用。(DEA procedure to solve multi-objective decision-making, program notes, some text, it is suitable for beginners.)

art CT成像追踪法源码 matlab实现(art CT)

根据系统的输入和输出，辨识系统的的传递函数。该系统为6阶系统，通过降阶降为2阶后，加入状态反馈和状态观测器，调整参数使2阶系统稳定，最后用于控制原6阶系统。阶跃响应和bode图效果都不错。(Based on the input and output of the system, the transfer function of the system is identified. The system is a 6 order system. After the order is reduced to 2 order, the system is added with the state feedback and the state observer, which adjusts the parameters to make the 2 order system stable. Finally, it is used to control the original 6 order system. Step response and Bode figure results are good.)