U3

描述了仿真AMI码的产生，利用矩阵生成，描绘其波形和功率谱(Mesh simulation of a balanced system, the use of contrast to NRZ code, respectively, do not use the case of a balanced mesh)

说明：  KPCA降维处理，完整的运行程序，包括数据和参考文献(KPCA dimensionality reduction processing, complete operating procedures, including data and references)

完整的幅相调制信号可k阶非线性功率谱分析(Complete amplitude and phase modulated signal can be k-order nonlinear power spectrum analysis)

matlab code for hand geusture recognization

从图片中提取四种不同纹理特征，包括gabor、灰度共生矩阵、灰度直方图、灰度梯度共生矩阵纹理特征。(Four different texture features extracted the image, including gabor, GLCM, histogram, GGCM texture.)

matlab GUI串口通信，实时采集数据，曲线显示，接收和发送数据(matlab GUI serial communication, real-time data collection, curve display, receiving and sending data)

这是CISS会议上发表的著名论文“Tensor Canonical decomposition based method for blind identification of MIMO system with 3-input 2-output case”的源程序，主要是讲基于张量规范分解的多天线系统的忙识别问题，里边包含了相应的文章，可以一起对照着看。(conference on the famous treatise "Tensor Canonical deco mposition based method for blind identificati on of MIMO system with 3-input 2-output case, "the source procedures, primarily based on stress tensor decomposition of standardized multiple antenna system to identify problems in the 1980s, contained inside a corresponding article, can work together to look to see.)

Buck double loop control

主动频率偏移法的改进,可以作为参考，只是需要一定的文献才能看懂(this s a typical method to solve the problem about the isolated land)

ANN on back propagation