Analysis_of_the_classic_tutorial_Matlab_function

auditry feture xtrction

sampling of rect signal

对具有随机噪声的二阶系统的模型辨识，进行标幺化以后系统的参考模型差分方程为 (7.90) 式中， 为随机噪声。由于神经网络的输出最大为1，所以，被辨识的系统应先标幺化，这里标幺化系数为5。利用图7.5正向建模(并联辨识)结构，神经网络选用3-9-9-1型，即输入层i，隐层j包括2级，输出层k的节点个数分别为3、9、9、1个； (Model identification of two order systems with stochastic noise)

这是matlab中实现PID位置控制算法程序(This is the matlab PID position control algorithm)

Kalman Filtering Theory and Practice Using MATLAB - Grewal and Andrews

粗差剔除程序，采用多项式拟合的方法对时间序列中的粗差进行剔除(Excluding gross error process, using polynomial fitting method of time series of gross errors culling)

跳频载波同步模块的matlab程序，对于做跳频通信系统给的非常好，直接用即可已测试。(Hopping carrier synchronization module matlab procedures for frequency hopping communication system to do very well, can be directly tested.)

说明：  a common use of fourier transforms is to find the frequency components

This code demomstrates an improved algorithm based on the local binary fitting (LBF) model in Chunming Li et al s paper: "Minimization of Region-Scalable Fitting Energy for Image Segmentation", IEEE Trans. Image Processing, vol. 17 (10), pp.1940-1949, 2008. Usage: These codes can be used for Matlab 7.0.4 or higher versions in Windows. Run the Demos in the M-files for several test images. Once an image comes out, click the mouse to generate a polygon as the initial contour: left click to get a number of points, then right click to get the end point. The number of iterations may need to be increased if the initial contour is too far away from the desired object boundary.

BRAIN TUMOR RECONSTRUCTION TECHNIQUE